Answer:
Class of fit:
Interference (Medium Drive Force Fits constitute a special type of Interference Fits and these are the tightest fits where accuracy is important).
Here minimum shaft diameter will be greater than the maximum hole diameter.
Medium Drive Force Fits are FN 2 Fits.
As per standard ANSI B4.1 :
Desired Tolerance: FN 2
Tolerance TZone: H7S6
Max Shaft Diameter: 3.0029
Min Shaft Diameter: 3.0022
Max Hole Diameter:3.0012
Min Hole Diameter: 3.0000
Max Interference: 0.0029
Min Interference: 0.0010
Stress in the shaft and sleeve can be considered as the compressive stress which can be determined using load/interference area.
Design is acceptable If compressive stress induced due to selected dimensions and load is less than compressive strength of the material.
Explanation:
Answer:
The digitization of performance management not only provides more precise data but also positively influences management processes and strategic development. Technology-enabled performance management tools simplify the manager's evaluation process and turn employees into active participants in their review sessions
A high voltage!! Hope this helps
Explanation:
uuui ielts k oshru with the best of my life u
Answer:critical stress= 20.23 MPa
Explanation:
Since there was an internal crack, we will divide the length of the internal crack by 2
Length of internal crack, a = 0.7mm,
Half length = 0.7mm/2= 0.35mm changing to meters becomes
0.35/ 1000= 0.35 x 10 ^-3m
The formulae for critical stress is calculated using
σC = (2Eγs /πa) ¹/₂
σC = critical stress=?
Given
E= Modulus of Elasticity= 225GPa =225 x 10 ^ 9 N/m²
γs= Specific surface energy = 1.0 J/m2 = 1.0 N/m
a= Half Length of crack=0.35 x 10 ^-3m
σC= (2 x 225 x 10 ^ 9 N/m² x 1.0 N/m /π x 0.35 x 10 ^-3m)¹/₂
=(4.5 x 10^11/π x 0.35 x 10 ^-3)¹/₂
=(4.0920 x10 ^14)¹/₂
σC=20.23 x10^6 N/m² = 20.23 MPa
