Answer:
Place an ACL on the line when configuring the RO community string.
Explanation:
Controlling Access via SNMP
SNMP is a protocol used by network management systems to monitor and control network-attached devices. Ciscoworks, HP Openview, and other management stations all use SNMP.
SNMP access can be granted on a network device in two ways—read-only and read-write. Read-only access allows the management station to poll the device for statistics and other information, but it does not allow anything to be changed. Read-write access allows the management station to make changes to the configuration of the device.
It's obviously a good idea to make sure you trust the devices allowed to make changes to your configuration, but some versions of SNMP use only a simple shared password to permit access. To make this more secure, an ACL can be applied, which limits the source IP addresses that can use SNMP.
Answer:
First, you need to start the OSPF process by executing the command:
<em>Router (config)# router ospf {process-ID#}</em>
Then, you have to instruct the router to advertise the networks that are directly linked to it by entering this network command with the area ID number for that network:
Router (config-router)# network {192.168.10.0} {255.255.255.0} area {0}
Answer:
Down/down is the correct answer.
Explanation:
The down/down is the status of the interface when the speed of the ethernet mismatches that is configuration between the Cisco routers. Generally, it is the way of saying by the Cisco is "the connection" or the following ports are available for the connection but do not have one of them then, check their systems or the cables connection.
Answer:
D) Engineering and Technology
Explanation:
Brent Designs or <em>Engineers </em>the equipment or<em> Technology </em>that is used to keep the plant safe.
