Answer:
If Corey wants to control the pacing of his presentation, he should adjust his playback settings. In the playback settings, he should select the default setting under "type;" this will allow him to change slides anytime. He should also click the check box under "options" that says "Change slides manually" so he can simply click on the slide whenever he is ready to move on to another slide.
Explanation:
If you don't like that answer, here's another one:
Corey knew he would need a lot of time to explain each point and that his team members would have lots of comments and questions. The best way that Corey should set up his slide show would be to make sure that he has an outline. Also, there should only be one thought per slide (never mix it). It has to be taken into account that he should have fewer words and more images/graphs.
<u>Answer:</u>
The correct answer option is C. near right.
<u>Explanation:</u>
The most accurate readings that you can take on an analog VOM are when the meter's pointer is near right.
There are two reasons behind this: readings towards the left end are likely to be off because of the incorrect adjustment of the zero adjust screw.
While readings at the left side may result in an inaccuracy in your reading as a smaller part of the total voltage is near the full scale.
The following options helps keep people from slipping on floors
A) Have the proper absorbents in an easy-to-find place to quickly put on spills : So that accidental little spills can be cleaned right away.
C) Wear slip-resistant footwear : It is a precautionary step to follow, no matter where we go.
D) Mark a slippery area with an easy-to-use tent sign that says " Caution, Slippery floor" : This allows people to be aware of the wet area and cross it cautiously.
Leaving oil and fluids to air dry thoroughly, takes a long time and there are chances that people step over it and slip.
So, the answer is
(B) Anytime oil or fluids are spilled on the floor, leave them to thoroughly air dry.
