Based on the configuration written below, the most likely cause of the problem is Incorrect subnet mask.
<h3>What is an Incorrect Subnet Mask?</h3>
The issue of an Incorrect Subnet Mask will take place if a network uses a subnet mask that is not theirs for its address class, and a client is still said to be configured with the same default subnet mask for the address class, and thus communication tend to fail to some closeby networks.
Therefore, Based on the configuration written below, the most likely cause of the problem is Incorrect subnet mask.
Learn more about subnet mask from
brainly.com/question/27418272
#SPJ1
See full question below
You manage a network that has multiple internal subnets. You connect a workstation to the 192.168.1.0/24 subnet.
This workstation can communicate with some hosts on the private network, but not with other hosts. You run ipconfig /all and see the following:
Ethernet adapter Local Area Connection: Connection-specific DNS Suffix . : mydomain.local Description . . . . . . . : Broadcom network adapter Physical Address. . . . . . : 00-AA-BB-CC-74-EF DHCP Enabled . . . . . . . : No Autoconfiguration Enabled. . . : Yes IPv4 Address . . . . . . . : 192.168.1.102(Preferred) Subnet Mask. . . . . . . . : 255.255.0.0 Default Gateway . . . . . . : 192.168.1.1 DNS Servers . . . . . . . : 192.168.1.20 192.168.1.27
What is the most likely cause of the problem?
Option D is correct. If we want multiple users to access data, we will organise that data in Database we can then be accessed whenever needed.
Answer:
i think A. is the answer but if it isn't B. Taking courses through the GI Bill is correct
Explanation:
i have multiple friends that are recruiters and i'm in rotc.
Answer:
C. ground antennas
Explanation:
AKA Satellite Dishes That Communicate Just Like Direct Tv dish It is focused by a bowl-shaped parabolic dish onto a device in the center called a "feed horn", which channels the signal to a "low-noise block down converter" (LNB) which filters out unwanted interference, and sometimes converts it to yet another frequency before amplifying it and sending it to the satellite receiver
Answer:
Tell her to hold the Shift key as she hits Enter.