Hi there!
The answer is $140.
Could you please Brainliest me?
Answer:
Terrence's
Step-by-step explanation:
The length of the square that will be cut out is the height of the box.
1. a
Anya's method: 8.5 -1.5 =7, 11- 1.5 =9.5, the height is 1.5, so the volume is height x length x width which is 1.5 x 9.5 x 7 =99.75 squared inches.
Terrence's method: 8.5-3 = 5.5, 11-3 = 8. Vol= 5.5 x 8 x 3 =132 squared inches. 99.75 < 132 squared inches, Terrence's idea would create larger volume.
1. b
The box's size depends on the length/width/height of the cardboard being cut, which is why different measurements / cutting methods for the same size cardboard can result in different box sizes.
2. The square would be cut from all four corners, therefore the sum of the 2 squares on the cardboard cannot exceed the short side of the cardboard. The shorter side of the cardboard is 8.5 inches, divided by 2 = 4.25 inches, hence the squares cannot be larger than 4.25 inches. Keep in mind that if you cut exactly 4.25 inches you will have a strip of 2.5 inches width that cannot be turned into a box.
If you want to cut 5 inches squares out, depending on how you draw it, it would either overlap or go outside of the paper because 5+5 is ten, surely on the 11 inches side that would still be perfectly fine but for the 8.5 inches side, there isn't any room for the 10 inches.
Answer:
The best measure of center for this dot plot is the median.
Choice A
Step-by-step explanation:
measures of center or location of a data set include;
the mean
the mode
the median
If a data set is symmetric or approximately normal then the best measure of center is the mean. On the other hand, for an asymmetric data with outliers the best measure of center is the median since it is robust to outliers.
Answer:
25 o, 75 o, 80 o
Step-by-step explanation:
because a full triangle is 180 degrees therefore 25 + 75 + 80 equals to 1 80
please mark me brainest
The definition an oblique cylinder has the same volume as a right cylinder of the same base and height. So the Volume of Cylinder B doesn't depend on the "lean" and is the same as Cylinder 'A'; 360 cu.cm.
