The geometric modeling is analyzed below.
<h3>How to illustrate the information?</h3>
Basic shapes are generally created using points, lines, circles, and triangles. Some basic shapes are rectangles, ellipses, triangles, and curves.
In geometric modeling, we make a cad model of parts for virtual analysis. By geometric modeling, one can model, and perform CAE analysis to optimize the product.
The best part is the period of doing all this is very small compared to practical manufacturing and looking at the product. In CAD one can very quickly alter the design and come up with new concepts in a very small span of time.
Here chances of error can be shorted easily and there is no wastage of material hence cost saving is there compared to practically manufacturing the part and altering it.
Learn more about modelling on:
brainly.com/question/28015639
#SPJ1
Answer:
monomial—A polynomial with exactly one term.
binomial— A polynomial with exactly two terms.
trinomial—A polynomial with exactly three terms.
Notice the roots: poly– means many.
Step-by-step explanation:
Hope it helps!!
Answer:
AD = 2.4
Step-by-step explanation:
All of the triangles in this figure are similar, so their corresponding sides have the same ratios.
The short side of ΔABD is 3/5 of the hypotenuse, which is 4.
AD/AB = CA/CB . . . . = short side/hypotenuse
AD = AB(CA/CB) = 4(3/5) = 2.4
The length of AD is 2.4 units.
_____
You can also go at this in terms of area.
A = 1/2bh = 1/2(3)(4) = 1/2(5)(AD) ⇒ AD = 12/5 = 2.4
