<span>Large headphones are essentially just two loudspeakers mounted on a strap that clamps firmly over your head. Earbuds work
the same way but, as you would expect, everything inside them (the
magnet, the coil of wire, and the diaphragm cone that makes sound) is
shrunk down to a much smaller size.</span>
In our bag, 1/2 is peanuts, 1/4 is chocolate and 1/4 is dried fruit.
The likelihood of drawing a chocolate therefore is 1/4.
The likelihood of drawing a peanut is 1/2 and the likelihood of drawing a dried fruit is 1/4.
Thus, D is the correct answer because the 1/4 likelihood of drawing a chocolate is less than the 1/2 chance of drawing a peanut.
Answer:
a=input("Amount in pennies")
b=int(a)
dollars=0
dimes= 0
quarters=0
nickels=0
pennies = 0
dollars = int(b/100)
b= b- dollars *100
quarters=int(b/25)
b=b-quarters*25
dimes = int(b/10)
b = b -dimes*10
nickels=int(b/5)
b=b - nickels * 5
pennies = b
print(dollars)
print(dimes)
print(nickels)
print(pennies)
Explanation:
The required program is in answer section. Note, the amount is entered in pennies.
Answer:
While statements determine whether a statement is true or false. If what’s stated is true, then the program runs the statement and returns to the first step. If what’s stated is false, the program exits the while and goes to the next statement. An added step to while statements is turning them into continuous loops. If you don’t change the value so that the condition is never false, the while statement becomes an infinite loop.
If statements are the simplest form of conditional statements, statements that allow us to check conditions and change behavior/output accordingly. The part of the statement following the if is called the condition. If the condition is true, the instruction in the statement runs. If the condition is not true, it does not. The if statements are also compound statements. They have a header (if x) followed by an indented statement (an instruction to be followed is x is true). There is no limit to the number of these indented statements, but there must be at least one.
Answer:
As a design rule, access points within range of each other should be set to channel frequencies with minimal signal overlap. Users will find that roaming doesn’t work well, and performance will degrade because of interference between access points.
Explanation:
