Internet Control Messaging Protocol
If you use the -T switch, it'll be TCP
I guess the correct answer is Embedded system.
Systems such as smartphones, appliances, game controllers, cable set-top boxes and automobiles that contain small computers are called Embedded systems.
Answer:
A and C
Explanation:
Option A:
In IPv6 there is a rule to reduce an IPv6 address when there are two or more consecutive segments of zeros just one time. This rule says that you can change the consecutive zeros for “::”
Here is an example
How to reduce the following IPv6 address?
ff02:0000:0000:0000:0000:0000:0000:d500
Ans: ff02::d500
Example 2:
2001:ed02:0000:0000:cf14:0000:0000:de95
Incorrect Answer -> 2001:ed02::cf14::de95
Since the rule says that you can apply “::” just one time, you need to do it for a per of zero segments, so the correct answer is:
Correct Answer -> 2001:ed02::cf14:0:0:de95
Or
2001:ed02:0:0:cf14::de95
Option C:
Since in IPv6 there are 
available addresses which means 340.282.366.920.938.463.463.374.607.431.768.211.456 (too many addresses), there is no need of NAT solution, so each device can have its own IP address by the same interface to have access through the internet if needed. If not, you can block the access through internet by the firewall.
Answer:
A binary system is a system that functions on zeros and ones (0's and 1's).
A decimal system is an Arabic numeric system that has 10 as its base and uses a dot which is also called a decimal point to show fractions.
Differences
- A decimal uses ten different digits which is 0-9 while a binary system uses just two digits 0 and 1
- Decimal system was historically a Hindu-Arabic system while the binary system is just an Arabic system
Similarities
- They are capable of performing arithmetic operations
- They both can be represented in decimal form
Answer:
The formula to enter in E14 is as follows:
=DAYS(D14,$E$10)
Explanation:
Required
Formula to calculate the number of days between E10 and D14
The syntax to do this is:
=DAYS(end_date,start_date)
So, we have:
=DAYS(D14,E10)
The question requires a mix of relative and mixed references because cell E10 will be constant in calculating the difference for dates in other cells.
In other words, the initial date is constant for all
So, the update formula is:
=DAYS(D14,$E$10)
Notice the $ between in E10; this represents mixed referencing
When dragged to E15 till E68, the formulas in the respective cells will be:
=DAYS(D15,$E$10) .............................. =DAYS(D68,$E$10)
