Answer:
Total Memory= 4 KB = 4096 bytes = 32768 bits
Explanation:
<em><u>1. Data lines are 8 From D0 to D7</u></em>
so
Total memory at single address locations is 8 bits.
<em><u>2. Address lines are 12 (A0 to A11)</u></em>
There are 12 address lines but 3 out 12 are for selction of chip or memory bank.
so only 9 pins are there to address the locations on one chip.
Total No. of address locations on single chip = 2^9 = 512 locations
as 1 location is 1 byte so total memory of single chip is 512 bytes.
<u><em>3. Total Memory Bank </em></u>
There are total 3 selection pins for memory bank.
so
Total chips = 2^3 = 8.
<em><u>4. Total Memory </u></em>
Total size of 1 chip = 512 bytes
Total size of 8 chip = 8x512 bytes = 4096 bytes = 4096/1024 kb = 4 kb
<em>So total memory of system is 4 Kb = 4096 bytes = 32768 bits</em>
Answer:
Layer 4 security and application services, including server load balancing, Secure Sockets Layer (SSL) offloading, firewalling, and intrusion prevention system (IPS) services are provided by the data center <u>aggregation</u> layer.
Explanation:
Consider the given information.
A key point for security and application services is the aggregation layer. In the data centre aggregation layer, the Layer 4 security and application services provide server load balancing, SSL offloading, firewalling, and IPS services.
Layer 4 security and application services, including server load balancing, Secure Sockets Layer (SSL) offloading, firewalling, and intrusion prevention system (IPS) services are provided by the data center <u>aggregation</u> layer.
Answer:
d. Individually testing a small part (or unit) of a program, typically a function, using a separate program called a test harness.
Explanation:
A software development life cycle (SDLC) can be defined as a strategic process or methodology that defines the key steps or stages for creating and implementing high quality software applications. There are seven (7) main stages in the creation of a software and these are;
1. Planning.
2. Analysis.
3. Design.
4. Development (coding).
5. Testing.
6. Implementation and execution.
7. Maintenance.
Unit testing can be defined as a software development procedure that involves the process of individually testing a small part (or unit) of a program, typically a function, using a separate program called a test harness.
This ultimately implies that, if the observed behavior of the small part of a software program is consistent with the expectations, then the unit test is considered a pass. Otherwise, the unit test failed.
Answer:
In some cases, one con is that it can be hard to keep track of your identation when coding long lines or blocks. The pro is that you may need to learn, which is not a bad thing. Learning is good.
