The closing entry for dividends involves a debit to <u>A. Retained Earnings</u> and a credit to <u>Dividends</u>.
<h3>What is a closing entry?</h3>
A closing entry is the journal entry at the end of the accounting period so that temporary ledger accounts (mainly income statement items) are moved to permanent accounts (balance sheet items).
<h3>Answer Options:</h3>
A. Retained Earnings; Dividends
B. Dividends; Retained Earnings
C. Dividends; Dividends Payable
D. Dividends Payable; Dividends
Thus, the closing entry for dividends is a debit to Retained Earnings, which is a permanent account, and a credit to Dividends (a temporary account).
Learn more about closing entries at brainly.com/question/13408214
A antonym for delicate could be firm
Answer:
the ending inventory using the LIFO method is $1,225
Explanation:
The computation of the value of the inventory using the LIFO method is shown below;
Since there are 196 closing units
So,
= 146 units × $6 + 49 units × $7
= $882 + $343
= $1,225
The $6 come from
= $882 ÷ 147 units
And, $7 comes from
= $1,372 ÷ 196 units
Hence, the ending inventory using the LIFO method is $1,225
Answer:
The correct answer is: the additional product generated by additional units of an input will eventually diminish.
Explanation:
The law of diminishing marginal returns states that with each additional unit of input employed the marginal product of each additional input will go on declining.
This is why the total product will increase at first but after reaching a certain point it will start declining. The total product will be maximum at the point where the marginal product is zero. When marginal product becomes negative the total product will decline.
Answer:
a. Subassemblies
Explanation:
Subassemblies are one of the inputs to manufacturing and service-delivery processes. This is because these are small units that need to be assembled separately but then later become part of the final larger manufactured product. Therefore since they are part of the final manufactured product they are an input in the manufacturing process of that larger product needed in order for it to be finished.