Answer:
Following are the solution to this question:
Explanation:
In point A:
It applies the AND operation with the subnet-mask that is
This corresponds to a 128.96.39.0 subnet. This is why the router sent the packet to 0.
In point B:
It applies the AND operation with the subnet-mask that is
This suits the 128.96.40.0 subnet. The router then sent R2 to the packet. The packet.
In point C:
It applies the AND operation with the subnet-mask that is
It applies the AND operation with the subnet-mask that is
All of the matches of its sublinks above.
Its default R4 router was therefore sent to the router by router.
In point D:
It applies the AND operation with the subnet-mask that is
It matches the 192.4.153.0 subnet. It router has sent packet to R3 then.
In point E:
It applies the AND operation with the subnet-mask that is
There, neither of the subnet inputs correlate with the ip address with the same subnet mask.
It applies the AND operation with the subnet-mask that is
It does not correlate to the subnet entries for same subnet mask, and therefore neither of the entries matches their corresponding ip address entries.
Mask of the subnet. That packet would therefore be sent to the default R4 router by the router.