Answer:
clipart ...........................
Explanation:
clipart is the correct answer for the above question.
You are using a device that reads the physical addresses contained in incoming data that travels along network cables. Based on the physical address that it reads, the device then forwards the data out one of its ports to reach the destination device. The type of device you are using is router.
<h3>What is Router?</h3>
A router is an hardware device that is used in transferring information or data from a system to another.
The data can also be transfered from one computer networks to another.
Router makes it easier for more than one device to be connected easily without difficult Internet access.
Therefore, The type of device you are using that reads incoming data that travels along network cables is router.
Learn more on router below
brainly.com/question/24812743
#SPJ1
Answer:
Total Memory= 4 KB = 4096 bytes = 32768 bits
Explanation:
<em><u>1. Data lines are 8 From D0 to D7</u></em>
so
Total memory at single address locations is 8 bits.
<em><u>2. Address lines are 12 (A0 to A11)</u></em>
There are 12 address lines but 3 out 12 are for selction of chip or memory bank.
so only 9 pins are there to address the locations on one chip.
Total No. of address locations on single chip = 2^9 = 512 locations
as 1 location is 1 byte so total memory of single chip is 512 bytes.
<u><em>3. Total Memory Bank </em></u>
There are total 3 selection pins for memory bank.
so
Total chips = 2^3 = 8.
<em><u>4. Total Memory </u></em>
Total size of 1 chip = 512 bytes
Total size of 8 chip = 8x512 bytes = 4096 bytes = 4096/1024 kb = 4 kb
<em>So total memory of system is 4 Kb = 4096 bytes = 32768 bits</em>
c.<span>barriers to communication
because the other employees are the ones causing the trouble</span>
Answer:
negatives = []
zeros = []
positives = []
while True:
number = input("Enter a number: ")
if number == "":
break
else:
number = int(number)
if number < 0:
negatives.append(number)
elif number == 0:
zeros.append(number)
else:
positives.append(number)
for n in negatives:
print(n)
for z in zeros:
print(z)
for p in positives:
print(p)
Explanation:
Initialize three lists to hold the numbers
Create a while loop that iterates until the user enters a blank line
Inside the loop:
If the number is smaller than 0, put it in the negatives list
If the number is 0, put it in the zeros list
Otherwise, put the number in the negatives list
When the while loop is done, create three for loops to print the numbers inside the lists
