Red Orange Yellow Green Blue Indigo Violet
<---Longest wave length shortest wave length--->
As you went down the colors of the rainbow the wave length got shorter or faster.
Sound quality can be divided into amplitude, timbre and pitch. If there’s an impedance mismatch between your two devices connected to the single output, you could have a large mismatch between the levels arriving at each device. If the difference is large enough, one device may have distorted or inaudible audio.
To avoid this, you should ensure that both devices connected to the split signal are similar - such as 2 pairs of headphones, 2 recorder inputs, and so on. When you place 2 devices with wildly differing load impedances on a splitter is when you’ll encounter problems - such as headphones on one split and a guitar amp input on the other.
To get around this, you can use either a distribution amplifier (D.A.) or a transformer balanced/isolated splitter - which will work over a larger range of load impedances, typically. Depends on the quality of the splitter and the exact signal path. If you’re using the splitter to hook two things into one input, and you’re using quality connectors, you probably won’t lose much quality. There can be an increase in impedance of the cable due to the imperfect continuity of the physical connection, however with unbalanced line-level signals, impedance at both ends of the chain tends to be orders of magnitude higher than the connection will create, so one split will be barely noticeable. So too, the noise increase from the additional length of cable.
Now, one source into two inputs, that will by basic math and physics result in a 3dB drop in signal strength, which will reduce SNR by about that much. By splitting the signal path between two inputs of equal impedance, half of the wattage is being consumed by one input and half by the other (the equation changes if the inputs have significantly different impedances). So each input gets half the wattage produced by the source to drive the signal on the input cable, and in decibel terms a halving of power is a 3dB reduction. Significant, until you just turn the gain back up. The “noise floor” will be raised by however much noise is inherent in the signal path between the split and the output of the gain stage; for pro audio this is usually infinitesimal, but consumer audio can have some really noisy electronics, both for lower cost and because you’re not expected to be “re-amping” signals several times between the source and output.
Answer:
Explanation:
As a microbiologist there are different methods are devised for characterization of microbes.such as Macroscopic analysis and microscopy method.
With the help of microscope the needed information about the individual cell such as individual cellular characteristics can be obtained, the magnification help to provide the features such as size, shape and motility of the microbes which helps to know the specific microbes characters.
When handling an unknown environmental microbe, with help of the cell characteristics of the microbes obtained using the microscope, the identity as well as metabolic characterization can be known such as the type of environment the microbes can survive in(aerobic or anaerobic), the source of food.
No growth was observed on the control plate.
The growth on the control plate indicates that the aseptic technique devised in the model was an adequate method for the prevention of the control plate from been contaminated.
1.Biological species concept
2.Cladistic species concept
3.Cohesion species concept
4.Competition species concept
5.Ecological species concept
6.Evolutionary species concept
7.Isolation species concept
8.Phenetic species concept
9.Phylogenetic species concept
10.Recognition species concept
11.Typological species concept
For descriptions just look them up :)
The analysis ToolPak is an add-in for Microsoft Excel program. The analysis ToolPak contains data analysis tools that can be used for financial, engineering and statistical data evaluation. The analysis Toolpak can be activated through the following sequence of steps;
File-->Options-->Add-ins -->Manage Excel Add-Ins --> Go.
