Answer:
9/32 inch diameter pin will not fit into a reamed hole with a diameter of 0.278 inch
Step-by-step explanation:
Diameter of reamed hole = 0.278 inch
Radius of reamed hole = 
Surface area of reamed hole = 
Surface area of reamed hole = 
Surface area of reamed hole = 0.06066794
Diameter of pin = 
Radius of pin =
Surface area of pin = 
Since the surface area of pin is more than the surface area of hole .
So, a 9/32 inch diameter pin will not fit into a reamed hole with a diameter of 0.278 inch
Answer:
Feet Above Sea Level
Step-by-step explanation:
A benchmark is a term in Surveying and Geo informatics, that describes a point of reference established at a known elevation which serves as basis in which other elevation or topographical point can be measured.
Therefore, when determining the benchmark, it's height is calculated relative to the vertical datum of the area, typically mean sea level, which is then recorded in FEET ABOVE SEA LEVEL.
Hence, Benchmarks measurements refer to FEET ABOVE SEA LEVEL.
Answer:
10
Step-by-step explanation:
7-(-3)
=7+3
=10
Hope this is helpful
60 to the negative 3 power