The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
Step-by-step explanation:
) Every positive rational number is greater than 0.
(ii) Every negative rational number is less than 0.
(iii) Every positive rational number is greater than every negative rational number.
(iv) Every rational number represented by a point on the number line is greater than every rational number represented by points on its left.
(v) Every rational number represented by a point on the number line is less than every rational number represented by paints on its right
b
Answer:
2/3
Step-by-step explanation:
20% = 12
48
1/6 = 8
left = 40
40/60 = 4/6
4/6 = 2/3
I think B not 100%shure ,you could prob go ask this on yahoo and get a bit more help ;) sorry I couldent help more
