Enroll a student identified by her snum into the class named 'Introduction to Database Systems' is the following transactions, state the SQL isolation level you would use.
1. Enroll a student identified by her snum into the class named 'Introduction to Database Systems'.
<u>Explanation:</u>
Since enroll is unique in the university enrollment database schema and field name is SNUM and it is data type is an integer. To identify student class name and department name and name of student SNUM field is used for searching in university enrollment database schema. Enrollment changing is not possible of the student’s not possible or not good practices in university enrollment database schema.
If a query had been made class wise or department wise enrollment is played an important role.
For assign, a faculty is made on the class id or department id.
Answer:
Explanation:
One group of students did an experiment to study the movement of ocean water. The steps of the experiment are listed below.
Fill a rectangular baking glass dish with water.
Place a plastic bag with ice in the water near the left edge of the dish.
Place a lighted lamp near the left edge of the dish so that its light falls directly on the plastic bag.
Put a few drops of ink in the water.
The student did not observe any circulation of ink in the water as expected because the experiment had a flaw. Which of these statements best describes the flaw in the experiment? (2 points)
Not enough ink was added.
Not enough water was taken.
The dish was too small for the experiment.
The lamp and the ice bag were at the same place.
Answer:
12
Explanation:
According to Saddleback college located in California;
12 units are considered full-time student status.
You may take as little as 0.5 units or as many as 19.0 units during a single semester. To take more than 19 units you are required to obtain special permission from the Counseling Department.
for num in range(4):
print(num)
The output will be:
0
1
2
3
The for loop iterates through the numbers in the range function and prints those same numbers to the console.
Answer:
Question is incomplete. it needs a topology diagram and also it needs Router R1 table. I assume User has access to the topology and Routing table.
Below Configuration will help to fix ACL problem
Hosts from the 172.16.0.0/16 network should have full access to Server1, Server2 and Server3 but this is not currently the case, as L1 can’t communicate to Server2 or Server3.
Explanation:
Following Configuration on Cisco Router R1 will help to fix all the ACL problems.
enable
configure terminal
no ip access-list standard FROM_10
ip access-list standard FROM_10
deny host 10.0.0.2
permit any
exit
!
no ip access-list standard FROM_172
ip access-list standard FROM_172
permit host 172.16.0.2
exit
!
interface GigabitEthernet0/0
ip access-group FROM_192 out
end
write memory
!