Answer:
In the View tab, you will find Zoom Option. Set the Zoom level to 100%.
Explanation:
You need to set the Zoom level to 100%, And you can do this, by setting the zoom level to 100%, from the scroll bar. Or you can move to view tab in the main menu, and then in the Ribbon, you need to select the zoom % and set it to 100 percent. You will then be able to see the entire page. And if you want, you can increase the Zoom level to even further, for getting an even more clearer picture.
Answer:
The data is transformed to usually make it smaller. It can always be re-constructed back to the original.
Explanation:
I'm on the same lesson on code.org as you, so just go to the question before and the answer to that question was the answer! ;)
Let me know if you got it right!
Answer:
A router connects multiple computers to the Internet through a single connection. The router manages the flow of data, delivering the right information to each computer on the network. Routers may also be used to connect multiple networks. A managed router is a router that is owned and managed by a third-party.
Answer:
Modern (i.e 386 and beyond) x86 processors have eight 32-bit general purpose registers, as depicted in Figure 1. The register names are mostly historical. For example, EAX used to be called the accumulator since it was used by a number of arithmetic operations, and ECX was known as the counter since it was used to hold a loop index. Whereas most of the registers have lost their special purposes in the modern instruction set, by convention, two are reserved for special purposes — the stack pointer (ESP) and the base pointer (EBP).
For the EAX, EBX, ECX, and EDX registers, subsections may be used. For example, the least significant 2 bytes of EAX can be treated as a 16-bit register called AX. The least significant byte of AX can be used as a single 8-bit register called AL, while the most significant byte of AX can be used as a single 8-bit register called AH. These names refer to the same physical register. When a two-byte quantity is placed into DX, the update affects the value of DH, DL, and EDX. These sub-registers are mainly hold-overs from older, 16-bit versions of the instruction set. However, they are sometimes convenient when dealing with data that are smaller than 32-bits (e.g. 1-byte ASCII characters).
When referring to registers in assembly language, the names are not case-sensitive. For example, the names EAX and eax refer to the same register.
Explanation:
