The product in a chemical reaction is written on the Right side of the arrow, so
the product formed here in given reaction is :
- CaO (Calcium Oxide)
ASAP!!!!!!
2 answers:
You might be interested in
Answer:
The time taken by the brick to hit the ground, t = 0.84 s
Explanation:
Given that,
A brick falls from a height, h = 3.42 m
The initial velocity of the brick is zero.
Since the brick is under free-falling. The time equation of a free-falling body when the displacement is given is
t =
where,
h - height from surface in meters
g - acceleration due to gravity
on substituting the values in the above equation,
t =
= 0.84 s
Hence, time taken by the brick to hit the ground is t = 0.84 s
Answer:
See explanation
Explanation:
Notice that the condenser section includes both the hot water and space heater and station (3) is specified as being in the Quality region. Assume that 50°C is a reasonable maximum hot water temperature for home usage, thus at a high pressure of 1.6 MPa, the maximum power available for hot water heating will occur when the refrigerant at station (3) reaches the saturated liquid state. (Quick Quiz: justify this statement). Assume also that the refrigerant at station (4) reaches a subcooled liquid temperature of 20°C while heating the air.
Using the conditions shown on the diagram and assuming that station (3) is at the saturated liquid state
a) On the P-h diagram provided below carefully plot the five processes of the heat pump together with the following constant temperature lines: 50°C (hot water), 13°C (ground loop), and -10°C (outside air temperature)
b) Using the R134a property tables determine the enthalpies at all five stations and verify and indicate their values on the P-h diagram.
c) Determine the mass flow rate of the refrigerant R134a. [0.0127 kg/s]
d) Determine the power absorbed by the hot water heater [2.0 kW] and that absorbed by the space heater [0.72 kW].
e) Determine the time taken for 100 liters of water at an initial temperature of 20°C to reach the required hot water temperature of 50°C [105 minutes].
f) Determine the Coefficient of Performance of the hot water heater [COPHW = 4.0] (defined as the heat absorbed by the hot water divided by the work done on the compressor)
g) Determine the Coefficient of Performance of the heat pump [COPHP = 5.4] (defined as the total heat rejected by the refrigerant in the hot water and space heaters divided by the work done on the compressor)
h) What changes would be required of the system parameters if no geothermal water loop was used, and the evaporator was required to absorb its heat from the outside air at -10°C. Discuss the advantages of the geothermal heat pump system over other means of space and water heating
