Answer:
scale factor: 1.16
perimeters: 21.84 ft and 25.36 ft
<h3>2
Answers: Choice B and Choice D</h3>
==========================================================
Explanation:
Standard form will always have the largest exponents listed first on the left side. Then as you move to the right, the exponents will decrease. Choice B shows this with the exponents counting down (3,2). Choice D is a similar story with the exponents counting down (9,2,1,0). Think of -6x as -6x^1, and also think of the 10 as 10x^0.
Something like choice A is a non-answer because the term with the largest exponent 3 is buried in the middle, and not at the left side. The exponents are not in decreasing order. Choice C can be ruled out for similar reasons.
Side note: the largest exponent is the degree of the polynomial. This only applies to single variable polynomials.
Answer:
0, 1, 2, 3, 4 and 5
Step-by-step explanation:
In a nutshell, base six is a number system that employs the numbers 0 through 5 instead of 0 through 9 in each digit. As a result, a number that would be stated as 6 in base ten is written as 10. We count one, two, three, four, five, ten, eleven, twelve, thirteen, fourteen, fifteen, twenty, and so on.
Hello, this is a linear problem so we are working with y = mx + b
The problem tells us:
y = total cost
x = the megabytes of data that she used in a month
b = y-intercept, which is the initial value
The problem asks "Which part of the graph will represent the cost per megabyte of data used in each plan?"
It is asking for cost per megabyte... This is a rate. and m = slope = rate
So lets, reiterate.
y = total cost
x = the megabytes of data that she used in a month
b = y-intercept, which is the initial value
m = slope = rate = cost per megabyte of data used
Answer: The slopes of the two lines.
It is D, because looking at a unit circle, 5pi/3 is about the same location as -sqrt3 which is approximately 1.4.
