Answer:
The ifconfig command.
Explanation:
A linux network system, like cisco networking devices, uses the linux operating system, in which it configuration differs from that of the cisco. It is very essential in network administration of have the basics in linux systems.
The network administrator uses the "ifconfig" command to display the IP addresses and subnet masks assigned to each network interface on a linux system.
In order to obtain a learners permit, teen drivers are required to pass a written test. Typically they will prepare for this exam by completing a drivers education course. Though not a requirement in all states, drivers ed is the easiest way to be thoroughly prepared for the complicated driving laws and scenarios you’ll face on the permit exam. Once you pass your permit test and earn a permit, there may still be certain restrictions attached to this provisional license — such as requiring a licensed driver over a certain age to be seated in the passenger seat, limiting your driving to daylight hours, and other state-mandated rules.
General United States Permit Requirements
While each state has its own set of guidelines, in general, teens between 14 and 18 years of age can start the drivers education and learners permit process. Once a teen driver has obtained a learners permit, there are additional state-specific requirements they must meet before they can apply for their drivers license.
Before obtaining a learners permit in any state, a teenager is required to pass a driving knowledge test. Drivers education is the best way for a teen to prepare for this exam, whether the state requires it or not. In some cases, passing a drivers ed final exam can substitute for the written exam. No matter how the test is taken, students must pass with at least a 70% or higher, depending on that state’s minimum. Once he or she passes, a teen driver will be issued a learners permit. Some states require teen drivers to have a permit for a minimum of 6 months before they can take their drivers license exam.
hope this helped :)
alisa202
Answer:
Read-only memory, also known as ROM, is a storage medium used in computers and electronic devices, which allows only the reading of information and not its writing, regardless of the presence or not of an energy source.
The data stored in the ROM cannot be modified, or at least not quickly or easily. It is mainly used to contain firmware (a program that is closely linked to specific hardware, and is unlikely to require frequent updates) or other vital content for device operation, such as programs that start up the computer and perform diagnostics.
There are three types of ROM memories: PROM. EPROM, and EEPROM.
Answer:
SD Cards and XDQ Cards are new XD Cards and CF Cards are old.
Explanation:
Hope this helps.
