Ask question

Ask question

All categories

3 years ago

13

A rock is thrown off a cliff at an angle of 57° above the horizontal. the cliff is 135 m high. the initial speed of the rock is

24 m/s. (assume the height of the thrower is negligible.) (a) how high above the edge of the cliff does the rock rise (in m)?

1 answer:

Anestetic [448]3 years ago

8 0

About 69 m in the sky

You might be interested in

Hello I need help with my science HW

inn [45]

Answer:

please put a picture, i dont know what you are doing so i cant help.

Explanation:

8 0

3 years ago

Usain Bolt accelerates at a rate of 3.7

MissTica

Answer:

Explanation:

I think that you to run more than 12 miles

4 0

4 years ago

What is your average speed if you walk 2km in 20 minutes

vlabodo [156]

You're average speed would be 6km/hour or 100m per minute.

6 0

3 years ago

A paper clip is pushed horizontally off a table with speed 1.5m/s. If the table has a height of 1.1m how far from the table does

Julli [10]

the answer is D. 0.71 m

3 0

3 years ago

Read 2 more answers

A Huge water tank is 2m above the ground if the water level on it is 4.9m high and a small opening is there at the bottom then t

lapo4ka [179]

Answer:

The speed of efflux of non-viscous water through the opening will be approximately 6.263 meters per second.

Explanation:

Let assume the existence of a line of current between the water tank and the ground and, hence, the absence of heat and work interactions throughout the system. If water is approximately at rest at water tank and at atmospheric pressure ( $P_{atm}$ ), then speed of efflux of the non-viscous water is modelled after the Bernoulli's Principle:

$P_{1} + \rho\cdot \frac{v_{1}^{2}}{2} + \rho\cdot g \cdot z_{1} = P_{2} + \rho\cdot \frac{v_{2}^{2}}{2} + \rho\cdot g \cdot z_{2}$

Where:

$P_{1}$ , $P_{2}$ - Water total pressures inside the tank and at ground level, measured in pascals.

$\rho$ - Water density, measured in kilograms per cubic meter.

$g$ - Gravitational acceleration, measured in meters per square second.

$v_{1}$ , $v_{2}$ - Water speeds inside the tank and at the ground level, measured in meters per second.

$z_{1}$ , $z_{2}$ - Heights of the tank and ground level, measured in meters.

Given that $P_{1} = P_{2} = P_{atm}$ , $\rho = 1000\,\frac{kg}{m^{3}}$ , $g = 9.807\,\frac{m}{s^{2}}$ , $v_{1} = 0\,\frac{m}{s}$ , $z_{1} = 6.9\,m$ and $z_{2} = 4.9\,m$ , the expression is reduced to this:

$\left(9.807\,\frac{m}{s^{2}} \right)\cdot (6.9\,m) = \frac{v_{2}^{2}}{2} + \left(9.807\,\frac{m}{s^{2}} \right)\cdot (4.9\,m)$

And final speed is now calculated after clearing it:

$v_{2} = \sqrt{2\cdot \left(9.807\,\frac{m}{s^{2}} \right)\cdot (6.9\,m-4.9\,m)}$

$v_{2} \approx 6.263\,\frac{m}{s}$

The speed of efflux of non-viscous water through the opening will be approximately 6.263 meters per second.

5 0

4 years ago