Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B say
2 answers:
You might be interested in
Answer:
Flow velocity
50.48m/s
Pressure change at probe tip
1236.06Pa
Explanation:
Question is incomplete
The air velocity in the duct of a heating system is to be measured by a Pitot-static probe inserted into the duct parallel to the flow. If the differential height between the water columns connected to the two outlets of the probe is 0.126m, determine (a) the flow velocity and (b) the pressure rise at the tip of the probe. The air temperature and pressure in the duct are 352k and 98 kPa, respectively
solution
In this question, we are asked to calculate the flow velocity and the pressure rise at the tip of probe
please check attachment for complete solution and step by step explanation
Answer:
The tube diameter is 2.71 mm.
Explanation:
Given:
Open glass tube is inserted into a pan of fresh water at 20°C.
Height of capillary raise is four times tube diameter.
h = 4d
Assumption:
Take water as pure water as the water is fresh enough. So, the angle of contact is 0 degree.
Take surface tension of water at 20°C as N/m.
Take density of water as 100 kg/m3.
Calculation:
Step1
Expression for height of capillary rise is gives as follows:
Step2
Substitute the value of height h, surface tension, density of water, acceleration due to gravity and contact angle in the above equation as follows:
m.
Or
d=2.719 mm
Thus, the tube diameter is 2.719 mm.