Answer:
Step 1
Elevate the front of the vehicle using the floor jack and support the vehicle with two jack stands. Make sure the vehicle is stable.
Step 2
Disengage all electrical components connected to the transmission. Indicate by marking the position of the drive shaft for its reinstallation. From the output shaft, remove the rear U joint. Jam the cloth to keep the liquid from dripping out of the extension housing.
Step 3
Loosen the shift linkages and the speedometer cable from the transmission manually. Place the transmission jack under the transmission, and then take a socket wrench and remove the support nut, the cross-member, and the rear support insulator from the rear engine. Support the engine with a jack stand and use the transmission jack to withdraw the transmission toward the rear of the vehicle.
Explanation:
Answer:
<u>Option 1</u>
Explanation:
As the team has already submitted the plans for the part drawing, the best way to proceed would be how it was given in the plans. Hence, the option to be selected :
- <u>Team member 1 suggests an orthographic top view because that is how the plans for the part were submitted.</u>
I'm not sure UBS hand UBS d es. used ins d UBS d jbs is. DHS. u s dibs us dibs de DJ d DJ is end dijjee job DJ dje had d USB e ujjde in dr. hvdn. jdjhe
Answer:
Explanation:
The determination of any further properties requires the knowledge of two independent properties. (Temperature and specific volume in this case). The specific volumes for saturated liquid and vapor at 140 °C are, respectively:
Since 
, it is a liquid-vapor mixture. The quality of the mixture is:
The specific enthalpies for saturated liquid and vapor at 140 °C are, respectively:
The specific enthalpy is:
