1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
tester [92]
3 years ago
10

A series circuit consists of a 0.440-H inductor, a 380.0-Ω resistor, a 5.70-μF capacitor, and an ac voltage source of amplitude

250.0 V. Find the rms voltage across the capacitor when the circuit operates at resonance.
A) 106 V
B) 129V
C) 95 V
D) 65 V
Engineering
1 answer:
algol [13]3 years ago
7 0

Answer: B) 129 V

Explanation:

If the circuit is operating at resonance, the capacitive reactance and the inductive one are equal each other, so that the circuit behaves like it were purely resistive.

This condition is verified when the ac voltage source operates at a given frequency, called resonance frequency, at which it is verified the following equality;

Xc = XL ⇒ 1/ω₀C = ω₀L

From this, we can find out the value of ω₀, as follows:

ω₀ = 1/√LC = 1/√0.44 H . 5.7. 10⁻⁶ F = 631.4 Hz

At resonance, the current I and the voltage are in phase, and I can be obtained applying Ohm's Law to the resistor R:

I = V/R = 250.0 V / 380.0Ω = . 66 A = 660 mA

The RMS value of this current, is just this peak value times √2/2, i.e.,

IRMS = .66 A . √2/2 = 0.46 A

The RMS voltage across the capacitor -which is numerically equal and opposite to the one across the inductor, is just  I times the capacitive reactance:

  • Vc = I . Xc = 0.46 A . 1/631.4 Hz. 5.7 . 10⁻⁶F = 129 V
You might be interested in
When a process is in a state of statistical control, all of the points on a control chart should fall within the control limits.
Mars2501 [29]

it is undesirable that all of the points should fall extremely near, or exactly on, the centerline of the control chart Because:

  • It can make it difficult  to interpret patterns and draw conclusions in a run chart.
  • It can lead hinder the process, and make it unstable.
<h3>When a data point falls outside the control limits of a run chart ?</h3>

If a data point falls is said to outside the control limits, we can say that the process is said to be out of one's control and it is good that an investigation is done to ascertain and remove the cause or causes.

So, it is undesirable that all of the points should fall extremely near, or exactly on, the centerline of the control chart Because:

  • It can make it difficult  to interpret patterns and draw conclusions in a run chart.
  • It can lead hinder the process, and make it unstable.

Learn more about data point from

brainly.com/question/3514929

#SPJ1

4 0
2 years ago
I have a question.What does DIY mean?
alexdok [17]

Answer: It means "Do it yourself".

Explanation: You're welcome!

6 0
3 years ago
Read 2 more answers
Show that -40 F is approximately equal to -40 C.
V125BC [204]

Answer: Please see below the explanation.

Explanation:

The Celsius (ºC) and Farenheit (ºF), are different temperature scales, but both have identifiable values for two important physical phenomena, water freezing point and water boiling point.

For º C, these are follows:

Freezing Point= 0º C            Boiling Point: 100ºC

For º F, we have the following:

Freezing Point= 32º F            Boiling Point: 212 ºF

Assuming that all steps (in each scale) between two following values are equal, we have 100 º C between both points in ºC, and 190º in ºF, so degrees in Farenheit are "shorter" than in Celsius, being the relationship, approximately the following:

1 º C = 9/5 ºF.

Taking into account that, by definition, 0ºC = 32º F, we can use the following equations in order to convert ºC to ºF, and viceversa:

ºC = (ºF-32) 5/9    

ºF = 32 + 9/5ºC

Now, let's calculate -40ºF, in ºC:

ºC= (-40-32)* 5/9 = -40º C

Let's do the same, converting -40ºC to ºF:

ºF = 32 + (-40)*9/5 = 32 + (-72) = -40ºF.

8 0
3 years ago
What is the resolution limit for a projection type of photolithographic system if the incident wavelength is 365 nm (the i-line
Vadim26 [7]

Answer:

Depth of field  = 347.619 nm

Explanation:

wavelenght =  365nm

N.A =0.63

k1= 0.6

so we have that the resolution limit is:

R=k1*A

R=0.6*365

R=219 nm

and the Depth of field needed for the best resolution is:

DoF = Resolution / N.A.

DoF= R/N.A

DoF= 219/0.63

DoF= 347.619 nm

7 0
3 years ago
The article "Display of Health Risk Behaviors on MySpace by Adolescents"† described a study in which researchers looked at a ran
nadya68 [22]

Answer:

True. 18-year old teenagers that practice some sport or have a hobby have less references to substance abuse or violence.

Explanation:

When someone practices a certain sport, he/she is occupied with its sport, also, sports encourage responsability, discipline and takes most of the person´s time and energy. People who doesn´t practice sports or have any hobby have more idle time and is always looking for something to take away the boredom. Most of the cases they start doing drugs or start having violent episodes because is what´s more handful and gives them the dopamine that the sport is not giving them (because they don´t practice any).

This is way the display of sports or hobbies involvements is associated with decreased references to risky behavior.

7 0
3 years ago
Other questions:
  • (a) If you needed to fit an acrylic base in a box that is 250mm x 250mm square, and the kerf on the laser cutter is 0.3mm, what
    13·1 answer
  • An incoming signal is at a frequency of 500kHz. This signal needs to be acquired and all other signals attenuated. Design a pass
    5·1 answer
  • Consider an experiment in which the number of pumps in use at each of two seven-pump gas stations was determined. Call the two g
    10·1 answer
  • If you know that the change in entropy of a system where heat was added is 12 J/K, and that the temperature of the system is 250
    10·1 answer
  • 1. When two vehicles moving at the same speed are involved in a collision, the vehicle that
    15·1 answer
  • That there is evidence of electrical failure given that there was a gas leak. Enter your answer in accordance to the item b) of
    13·2 answers
  • If noise levels are high enough that you have to raise
    7·1 answer
  • Which option identifies the tool best to use in the following scenario?
    13·1 answer
  • When you purchase commercial software you own the source code to that program. true false
    6·2 answers
  • Heater control valves can not leak coolant<br><br> True <br> False
    12·2 answers
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!