Answer:
This is because it steps up or steps down electrical voltage. It multiplies either voltage (if it is a voltage transformer )or current (if it is a current transformer), but it does not multiply electrical power.
Explanation:
A transformer steps up or steps down electrical voltage, by transmitting power at a voltage, V₁ and Current I₁ at one terminal, to a voltage, V₂ and Current I₂ at its other terminals, just like a lever transmits force from one point to another. Since the power transmitted remains the same, (energy per unit time remains constant), I₁V₁ = I₂V₂ ⇒ I₁/I₂ = V₂/V₁ = n (the turns ratio of the transformer). So, the turns ratio will determine if its a step-up or step-down transformer. V₂ = nV₁. So, if V₁ > V₂ it is a step down transformer and if V₁ < V₂ it is a step-up transformer.It multiplies either voltage (if it is a voltage transformer )or current (if it is a current transformer), but it does not multiply electrical power, since P = IV = constant for the transformer.
Answer:
A) for leftmost point the coordinate is -0.28m that means it should be 0.28m towards the right.
B) for rightmost case the coordinate is 0.28m which is where komila should sit.
Explanation:
Detailed calculation and explanation is shown in the image below
<span>carbon, hydrogen, and oxygen onLY</span>
D.) It is an "Element".
[ Element cannot be separated by any means ]
Hope this helps!
Answer:
Incomplete question
This is the completed question
If the resistor in the circuit had a larger resistance then the current would be then have to be proportionally smaller. Because the batteries each give off 1.5 volts then the current would have to be the variable that would change. What affect would using a 12V car battery have on the operation of your circuit? (Do not try this.) What would happen to the current? What would happen to the resistor?
Explanation:
Using ohms law as our basis
Ohms law state that, the voltage in an ohmic conductor is directly proportional to the current
V∝I
Resistance is the constant of proportionality
Then
V=iR
Since we want a relationship between current and resistance.
then, I=V/R
So, current is inversely proportional to Resistance
as the current increase the resistance reduce and as the current reduces the resistance increases.
a. So, increasing the voltage from 1.5V to 12V increases the current In the circuit because voltage Is directly proportional to I.
From ohms law
V=iR
When v =1.5V
I=1.5/R
When V increase to 12V
I=12/R
I.e, it increases by a factor of 8. Eight times it's initial value
b. Now, the resistance in the circuit is the constant of proportionality and it doesn't change in a given circuit expect when using a variable resistoa r like rheostat.
