Answer:Yes
Explanation:
Given
mass
mass
Force of magnitude =17 N
coefficient of static friction
Lower block is glued to floor
Force cos component will try to move the upper block while sin component try to lower the Normal reaction
Normal reaction
and friction force
And force cos component =
As force cos component is more than the friction force therefore it slips w.r.t to lower block
While the Orion constellation is named after the hunter in Greek mythology, it is anything but stealthy. Orion, which is located on the celestial equator , is one of the most prominent and recognizable constellations in the sky and can be seen throughout the world.
Answer:
Weight
a) weight's vertical component = Normal upward force
b) weight's horizontal component = Friction force = (mass of ball)(acceleration)
These forces depend upon the track,
1) inclined or horizontal
2) steepness.
Explanation
The force of gravity points straight down, but a ball rolling down a ramp doesn't go straight down, it follows the ramp. Therefore, only the component of the weight which points along the direction of the ball's motion can accelerate the ball.
weight's horizontal component = Friction force = (mass of ball)(acceleration)
The other component pushes the ball into the ramp, and the ramp pushes back.
If the ramp is horizontal, then the ball does not accelerate, as gravity pushes the ball into the ramp and not along the surface of the ramp. Hope this helps. Can u give me brainliest
Explanation:
Answer:
Understanding projections and coordinate systems important knowledge to have, especially if you deal with many different sets of data that come from different sources. Projections Distortion Coordinate Systems Datums
A Cartesian coordinate system. Locations on the Earth's surface are measured and represented in terms of coordinates; a coordinate is a set of two or more numbers that specifies the position of a point, line, or other geometric figure in relation to some reference system.
• Check Layer Properties > Source > Spatial Reference to find out what coordinate system your data is in. If it says “Unknown Coordinate System” you definitely want to use the Define Projection tool. • The Define Projection tool will not make a copy of your data.
Math coordinates identify the location of a point on a graph or map. The ordered pair, (x,y) is the address of the point. The Cartesian coordinate system is the graph used to locate the point.
Explanation: