1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Nutka1998 [239]
3 years ago
7

How would you find the atomic number, atomic mass, protons, neutrons and electrons for ions and isotopes? Is it similar?

Chemistry
1 answer:
cricket20 [7]3 years ago
7 0

Atomic number = number of protons

atomic mass = atomic number + number of neutrons

protons = electrons after ion effect

neutrons = atomic mass - atomic number

electrons = number of proton plus charge for -ve ion OR minus for +ve ion

They are different, representing different properties...

You might be interested in
Suppose your thermometer is off by 1.5 oc i.e. it reads values that are 1.5 oc higher. how would this affect the results in this
larisa86 [58]
I assume that the experiment is about calculating the enthalpy of a reaction. 
If you consistently use the thermometer for all procedure in the experiment, the effect will be negligible because all temperature will be increased by 1.5 °C.

In enthalpy calculation, the energy is determined by the temperature differences. If the final and initial temperature increased by 1.5 °C, then the difference will not be changed.
5 0
3 years ago
Write a paragraph (5-7 sentences) describing pH and conductivity.
PilotLPTM [1.2K]

Answer:

pH is a measure of hydrogen ion concentration, a measure of the acidity or alkalinity of a solution. The pH scale usually ranges from 0 to 14. Aqueous solutions at 25°C with a pH less than 7 are acidic, while those with a pH greater than 7 are basic or alkaline. A pH level of 7.0 at 25°C is defined as "neutral" because the concentration of H3O+ equals the concentration of OH− in pure water. On the other hand, electrical conductivity is a non-specific measurement of the concentration of both positively and negatively charged ions within a sample. So the short answer to the question is as follows, the presence of any hydrogen ions present in a substance will impact the pH level and most probably influence conductivity levels. However, hydrogen ions make up only a small part of the ion concentration measured by a conductivity meter.

4 0
2 years ago
Name 3 ways ecologist can estimte the size of population
sergiy2304 [10]
1. Count them
2. Trap, Mark, and Release
3. Sample Count

I hope this helps your score!!
8 0
3 years ago
The reaction A2 + 2 B → 2 BA is thought to occur by the following mechanism:
adelina 88 [10]

Answer:

c. Z is a catalyst, and ZA2 and A are reaction intermediates.

Explanation:

Overall reaction is given as;

A2 + 2 B → 2 BA

Mechanism:

Step 1: A2 + Z → ZA2

Step 2: ZA2 + B → BA + Z + A

Step 3: A + B → BA

The options given are centered upon catalysts and reaction intermediates. So before proceeding, we have to understand the difference between the two and how to identify them.

A catalyst is basically a reaction booster to speed up the rate of the reaction and the reaction intermediate is an unstable, temporl species formed from the reactants before getting to the products.

The difference is given as;

Catalysts are present as reactants in the very beginning and products at the end of the reaction.

Intermediates, on the other hand, are not present in the initial reaction but are produced within one of the steps and then consumed within another step.

Following the above, we can deduce that;

Z is a catalyst because it is present as a reactant in the beginning.

ZA2 and A are a reaction intermediates because they are not present in the overall reaction but are produced and consumed in one of the steps.

Correct option is given as;

c. Z is a catalyst, and ZA2 and A are reaction intermediates.

8 0
4 years ago
How many grams of sodium oxide can be produced when 55.3 g Na react with 64.3 g O2?. . Unbalanced equation: Na + O2 → Na2O. . Sh
GenaCL600 [577]
 <span>this is a limiting reagent problem. 

first, balance the equation 
4Na+ O2 ---> 2Na2O 

use both the mass of Na and mass of O2 to figure out how much possible Na2O you could make. 
start with Na and go to grams of Na2O 

55.3 gNa x (1molNa/23.0gNa) x (2 molNa2O/4 molNa) x (62.0gNa2O/1molNa2O) = 75.5 gNa2O 

do the same with O2 

64.3 gO2 x (1 molO2/32.0gO2) x (2 molNa2O/1 mol O2) x (62.0gNa2O/1molNa2O) = 249.2 g Na2O 

now you must pick the least amount of Na2O for the one that you actually get in the reaction. This is because you have to have both reacts still present for a reaction to occur. So after the Na runs out when it makes 75.5 gNa2O with O2, the reaction stops. 

So, the mass of sodium oxide is 

75.5 g</span>
3 0
3 years ago
Read 2 more answers
Other questions:
  • 34 What is the gram-formula mass of Fe(NO3)3?(1) 146 g/mol (3) 214 g/mol
    8·1 answer
  • Is ability to conduct heat physical or chemical
    9·1 answer
  • Word equation for Cu(s)+O2(g)=CuO(s)
    15·2 answers
  • - What would happen to the boiling point of a liquid if the volume of the liquid was doubled?
    12·1 answer
  • What is the relationship between the period and the orbital radius? Select one: a. It is a direct relationship- As the period in
    5·1 answer
  • What is Green Chemistry?
    6·1 answer
  • What is the number of electrons in the outermost energy level of an oxygen atom?
    13·1 answer
  • A group of students want to see how temperature affects the time spilled water to dry up what will be independent and dependent
    12·1 answer
  • A chloride of this element is 67.2% chlorine by mass. In a 100 g sample how many moles of chlorine are there? (This info will be
    9·1 answer
  • Giving brainliest to right answer
    10·2 answers
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!