Movement and balance are monitored by activity in the cerebellum.
<h3>What is meant by the cerebellum?</h3>
The cerebellum, also known as the "little brain" because it resembles a miniature cerebrum, is in charge of balance, movement, and coordination. The pons and medulla, along with the midbrain, are commonly referred to as the brainstem. The brainstem receives, sends, and coordinates messages from the brain.
The cerebellum is the area of the brain in charge of coordinating voluntary movements. It is also in charge of a variety of functions, including motor skills like balance, coordination, and posture.
The cerebellum is important for maintaining balance by making postural adjustments. It modulates commands to motor neurons based on input from vestibular receptors and proprioceptors to compensate for changes in body position or muscle load.
Therefore, the correct answer is option B) cerebellum.
To learn more about the cerebellum refer to:
brainly.com/question/5318535
#SPJ4
Answer:
See the answer below
Explanation:
<em>The carrying capacity of the ecosystem for the white-footed mouse reduced in response to the changes in the amount of worm infected mice in the population.</em>
The carrying capacity of an ecosystem for a particular population of organisms is the maximum number of organisms the ecosystem can support based on the resources it has.
<u>The ideal carrying capacity of the ecosystem for the white-footed mouse oscillates between 36 to 40 in graph 1. The carrying capacity range reduced in graph 2 from 36 - 40 to 30 - 36 as a result of changes made to the number of mice infected with parasitic worms in the population of the animal. </u>
Thus, the introduction of more worm-infected mice into the population probably put more pressure on the ecosystem resources thereby reducing the carrying capacity.
The warm water sinks and travels to areas where the water is cold then rises again. The cycle repeats.
The answer is B
Explanation. The density explains the amount of mass for how small or large an object is. Best way to test density is with water. If it is MORE DENSE (heavier in small area) it will sink.
Plasticity is to be molded. You can mold plastic is is bendable and heats up easily to give the advantage of being reshaped