I think the answer is 80 degrees. Think about it like you're moving the chunk with 100 degrees already filled in, to the space where you're trying to find the amount since they're the same. Vertical angles are supplementary and are equal to 180. So, 100+x = 180. x would equal 80 degrees.
Answer:
<h2>Leah is actually wrong, because those rectangles are similar.</h2>
Step-by-step explanation:
Remember that similarity is about having proportional sides and congruent angles. When we have congruent sides, then those rectangles are congruent not similar.
In this case, to find the similarity, Leah should compare bases and heights thorugh division, because the ratio between heights and the ratio between bases must be equal. So, let's divide.
As you can observe, both ratios are equal.
Therefore, those rectangles are congruent.
Of course not.
If the line rises higher as it goes from left to right,
then its slope ( 'm' ) is positive.
If it sinks lower as it goes from left to right,
then its slope ( 'm' ) is negative.
Answer:
B. load-distance model
Step-by-step explanation:
A. trial and error
Trial and error is "a fundamental method of problem solving. It is characterised by repeated, varied attempts which are continued until success". But this method is not the best in order to compare effectiveness of layouts
B. load-distance model
The load-distance method is a "mathematical model used to evaluate locations based on proximity factors. The objective is to select a location that minimizes the total weighted loads moving into and out of the facility. The distance between two points is expressed by assigning the points to grid coordinates on a map". And that's the correct option since we are trying to measure the effectiveness of layouts quantitatively.
C. exponential smoothing
This is "a rule of thumb technique for smoothing time series data using the exponential window function". Wheighting observations using the exponential function. But this is a techinique used to smooth s time series not to compare effectiveness of layouts.
D.process control charts
The Control Chart is a "graph used to study how a process changes over time with data plotted in time order". But we don't want to see how the process changes the objective is quantitatively compare the effectiveness of layouts, and this one is not the best option for this.
E. mean absolute deviation (MAD)
The median absolute deviation(MAD) is "a robust measure of how spread out a set of data is. The variance and standard deviation are also measures of spread, but they are more affected by extremely high or extremely low values and non normality". But again is just a measure of spread and not allow to compare effectiveness of layouts.
