Answer:
Explanation:
As you move down a group, first ionization energy decreases. WHY? Electrons are further from the nucleus and thus easier to remove the outermost one.
Number of moles of CO2 =
Mass /Ar
= 50.2 / (12 + 32)
1.14 mols
For every 1 mol of gas, there will be
24000 cm^3 of gas
Vol. = 1.14 x 24 dm^3
= 27.36 dm^3
Answer:
The main advantage would be that with the pouring temperature being much higher, there is very little chance that the metal will solidify in the mould while busy pouring. This will allow for moulds that are quite intricate to still be fully filled. The drawbacks, though, include an increased chance defects forming which relates to shrinkage (cold shots, shrinkage pores, etc). Another drawback includes entrained air being present, due to the viscosity of the metal being low because of the high pouring temperature.
I would go with C, because you would always start with products and end with reactants.
