I included my code in the picture below.
On a printed circuit board, electronic parts will be mounted from the substrate side of the board. The leads jab through the substrate and the copper sheeting that has been carved. The leads are then soldered to the copper.
I hope the answer will help you.
Answer: Detailed
Explanation:
SDLC consist of 7 phases. They are:
1. Planning.
2. System analysis and requirement
3. Design:
4. Coding:
5. Testing:
6. Installation
7. Maintenance
Here we are talking of the third phase. In this phase it is the design phase which consist of high and low level design. Here the preliminary design is included in high level design where it describes the required hardware, software, network capabilities and the modelling of the interface. However the detailed design in low level design will implement the coding and will finding of any errors in the implemented design as described by the preliminary design.
Parameter is the answer you wanted
