When you insert an chart in an Excel spreadsheet, Excel creates as a default an embedded chart. This embedded chart will show on your sheet. You will still be able to see other cells and figures in the sheet. An Excel Chart Sheet on the other hand is a worksheet tab that only contains the Excel chart. The difference between them is that a chart sheet is a separate tab in the sheets tabs and only has the chart on .
Answer:
Process re-design is the process in which re-work is done to achieve the improvement in the output. The major aim is to set the goals for achieving the main objective.
The various essential steps in the process of re-design are:
- Data capturing process are used to identify the process and making the necessary changes.
- Identify every step of the process to ensure that process is in organized way along with the workflow.
Re-engineering is the process of re-design the system with focuses to improve the efficiency and quality. It basically analysis the whole business re-engineering process. The main step is to identify the need for the changes.
Answer: False
Explanation: Even though you can remember it is not really good because some hackers can track you passwords through those websites and could hack your account.
Answer: Open Reliability Monitor.
Explanation:
The simplest way to view this information is to open the reliability monitor.
The Reliability Monitor shows you the stability history of a system at a glance and also allows one to see the details of the events that has an effect on reliability on a daily basis.
The reliability and problem history chart which can be seen in the Reliability Monitor helps in keeping track of the overall health of the server on a daily basis.
Answer:
The oldest of the hard drive connections are the SCSI (Small Computer System Interface) types. The 50 pin flat ribbon cable connectors were found in all sorts of computers and servers from their introduction in 1986 until the mid 1990's.
They are still in use today, albeit in their updated Ultra SCSI form which uses either 68 or 80 pin connectors along with a pinless plug that is similar to a USB connection. Up to 16 drives/devices can be connected through SCSI connections. {The common alternative to SCSI connectors is the IDE connection. Also known as ATA or PATA, IDE drives use a 40 pin flat ribbon cable and are limited to just two drives per cable. These drives were initially developed for IBM PCs.
}
Introduced in 2005 as a replacement for Ultra SCSI, SAS drives, or Serial Attached SCSI, share many common features with regular SCSI but offer many improvements. While SCSI drives can only run a single communication in the order it's received, SAS drives allow for multiple simultaneous communications through less numbers of pins and higher speeds. SAS plugs look similar to those found on SATA devices but have seven additional pins for a total of 29 (14 for data, 15 for power). SAS systems can also handle upwards of 66,000 devices per controller.
SATA, or Serial ATA, drives are similar to SAS but have a simplified plug with 15 power and seven data connections. SATA drives can technically plug directly into any cable that accepts a SAS drive but it may not been by the computer it is connected too if it doesn't support SATA drives on a SAS system.
Finally, FC or Fibre Channel drives are designed for larger storage systems that use fiber optic interconnects between the server and drive enclosures. The connections on Fibre Channel drives typically prevent them from being used with other drive types due to their specialty nature but since they are based on SCSI technology, they work easily with many different server systems.