Answer:
weightEarth = float(input("Enter weight on earth: "))
weightMoon = weightEarth/6
print("Weight on moon:", weightMoon)
Explanation:
You have to convert the string input into a float in order to do calculations with it.
1. false
2. d
3. b
4. a
5. b
6.c
7. b
8.a
9. d
10. b
11. d
12.a
13. c
14. c
15. a
A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment
Two factors may interfere with the copper cabling and result in signal distortion and data corruption are :
EMI
RFI
Explanation:
- EMI (electromagnetic interference) is the disruption of operation of an electronic device when it is in the vicinity of an electromagnetic field (EM field) in the radio frequency (RF) spectrum that is caused by another electronic device.
- During EMC testing, radiated emissions measurements are made using a spectrum analyzer and or an EMI receiver and a suitable measuring antenna.
- EMI (Electromagnetic Interference) is also called RFI (Radio Frequency Interference).
- Conducted RFI is unwanted high frequencies that ride on the AC wave form. Radiated RFI is emitted through the air. There are many pieces of equipment that can generate RFI, variable frequency drives included.
- The internal circuits of personal computers generate EM fields in the RF range.
Answer:
Answered below
Explanation:
aFile = open("books.txt", "r")
This code uses the function open() which takes two parameters. The first parameter is the file name while the second parameter is the mode in which you are accessing the file.
The "r" mode opens the file in a reading state. That is, you can only read from the file. This code completes the reading process
aFile.read( )
The "w" mode opens the file so you can write to it and make changes.
The "a" mode opens the file so you can add contents to it.
Answer:
Explanation:
One group of students did an experiment to study the movement of ocean water. The steps of the experiment are listed below.
Fill a rectangular baking glass dish with water.
Place a plastic bag with ice in the water near the left edge of the dish.
Place a lighted lamp near the left edge of the dish so that its light falls directly on the plastic bag.
Put a few drops of ink in the water.
The student did not observe any circulation of ink in the water as expected because the experiment had a flaw. Which of these statements best describes the flaw in the experiment? (2 points)
Not enough ink was added.
Not enough water was taken.
The dish was too small for the experiment.
The lamp and the ice bag were at the same place.