All categories

3 years ago

Which type of electromagnetic radiation has higher frequencies than visible light?

Physics

2 answers:

Goshia [24]3 years ago

6 0

Answer:

B RADIO WAVES

Explanation:

On one end of the electromagnetic spectrum are radio waves, which have wavelengths billions of times longer than those of visible light.

slamgirl [31]3 years ago

4 0

Answer:

Ultraviolet Radiation?!

Explanation:

You might be interested in

A skateboarder is moving at 1.75 m/s when she starts going up an incline that causes an acceleration of -0.20 m/s2

Rudiy27

Answer:

Approximately $7.66\; \rm m$ .

Explanation:

<h3>Solve this question with a speed-time plot</h3>

The skateboarder started with an initial speed of $u = 1.75\; \rm m \cdot s^{-1}$ and came to a stop when her speed became $v = 0\; \rm m \cdot s^{-1}$ . How much time would that take if her acceleration is $a = -0.20\; \rm m \cdot s^{-1}$ ?

$\begin{aligned} t &= \frac{v - u}{a} \\ &= \frac{0\; \rm m \cdot s^{-1} - 1.75\; \rm m \cdot s^{-1}}{-0.20\; \rm m \cdot s^{-2}} \approx 8.75\; \rm s\end{aligned}$ .

Refer to the speed-time graph in the diagram attached. This diagram shows the velocity-time plot of this skateboarder between the time she reached the incline and the time when she came to a stop. This plot, along with the vertical speed axis and the horizontal time axis, form a triangle. The area of this triangle should be equal to the distance that the skateboarder travelled while she was moving up this incline until she came to a stop. For this particular question, that area is approximately equal to:

$\displaystyle \frac{1}{2} \times 1.75\; \rm m \cdot s^{-1} \times 8.75\; \rm s \approx 7.66\; \rm m$ .

In other words, the skateboarder travelled $15.3\; \rm m$ up the slope until she came to a stop.

<h3>Solve this question with an SUVAT equation</h3>

A more general equation for this kind of motion is:

$\displaystyle x = \frac{1}{2}\, (u + v) \, t = \frac{1}{2}\, (u + v)\cdot \frac{v - u}{a}= \frac{v^2 - u^2}{2\, a}$ ,

where:

$u$ and $v$ are the initial and final velocity of the object,
$a$ is the constant acceleration that changed the velocity of this object from $u$ to $v$ , and
$x$ is the distance that this object travelled while its velocity changed from $u$ to $v$ .

For the skateboarder in this question:

$\begin{aligned}x &= \frac{v^2 - u^2}{2\, a}\\ &= \frac{\left(0\; \rm m \cdot s^{-1}\right)^2 - \left(1.75\; \rm m \cdot s^{-1}\right)^2}{2\times \left(-0.20\; \rm m \cdot s^{-2}\right)}\approx 7.66\; \rm m \end{aligned}$ .

6 0

4 years ago

1)If I'm on an elevator that breaks loose and plummets down the shaft, can I avoid harm by jumping at the last second?

umka2103 [35]

Answer and Explanation:

1) If you were to jump at the last second, you would decrease the impact velocity by 7 mph. This is because most humans have a maximum jump velocity of 7 mph. You may still get hurt, but the damage would be significantly less than if you were to not jump.

2) Bathroom mats are made of fabrics, and fabrics absorb the moisture in the air. If you were to take a shower at any temperature, the fabric will soak up the moisture in the air, so when you touch it, it doesn't feel cold.

The tile floor, however, isn't able to store the moisture into itself. The temperature of the tile will be less than the temperature of your feet.

<u><em>#teamtrees #PAW (Plant And Water)</em></u>

<u><em>I hope this helps!</em></u>

5 0

3 years ago

Lena helps a child who is choking on his food. Which reliable method prepared her for helping with this injury?

Ivanshal [37]

knowledge of first aid ... eg St John Ambulance, Red Cross etc. I think that everyone in a school should be taught First Aid.

7 0

3 years ago

Read 2 more answers

In the lesson a thermos is presented as an example of an isolated energy system. How could you change the thermos into an open e

iVinArrow [24]

If you want to change the thermos into an open energy system, you have to remove the lid. Once the lid is removed, the energy is no longer contained inside the thermos bottle. From the bottle, the energy dissipates to the environment.

7 0

4 years ago

Read 2 more answers

Explain why an experiment should test only one variable at a time

padilas [110]

We use only one variable at a time to find the accurate result. We want to see how the result of experiment changes everytime with a single variable.

4 0

3 years ago