Answer:
Question is incomplete. it needs a topology diagram and also it needs Router R1 table. I assume User has access to the topology and Routing table.
Below Configuration will help to fix ACL problem
Hosts from the 172.16.0.0/16 network should have full access to Server1, Server2 and Server3 but this is not currently the case, as L1 can’t communicate to Server2 or Server3.
Explanation:
Following Configuration on Cisco Router R1 will help to fix all the ACL problems.
enable
configure terminal
no ip access-list standard FROM_10
ip access-list standard FROM_10
deny host 10.0.0.2
permit any
exit
!
no ip access-list standard FROM_172
ip access-list standard FROM_172
permit host 172.16.0.2
exit
!
interface GigabitEthernet0/0
ip access-group FROM_192 out
end
write memory
!
You take a picture on your regular camera. Then you go you go to the thingamajigger that looks like a paper clip. You tap it and choose the photo.
The answer is <span>VPLEX.</span>
Answer:20*i
Explanation:
Because the size will expand as its being written out to then have i
