Answer:
6 grains
Explanation:
The equation of the reaction between NaOH and aspirin is;
C9H8O4(aq) + NaOH (aq) ------>C9H7O4Na(aq) + H2O(l)
Amount of NaOH reacted = concentration × volume = 0.1466 M × 14.40/1000 L = 2.11 × 10^-3 moles
Given that aspirin and NaOH react in a mole ratio of 1:1 from the balanced reaction equation above, the number of moles of aspirin reacted is 2.11 × 10^-3 moles
Hence mass of aspirin reacted = 2.11 × 10^-3 moles × 180.2 g/mol = 0.38 g
If 1 grain = 0.0648 g
x grains = 0.38 g
x= 0.38 g/0.0648 g
x= 6 grains
Answer:
Kc = 1.09x10⁻⁴
Explanation:
<em>HF = 1.62g</em>
<em>H₂O = 516g</em>
<em>F⁻ = 0.163g</em>
<em>H₃O⁺ = 0.110g</em>
<em />
To solve this question we need to find the moles of each reactant in order to solve the molar concentration of each reactan and replacing in the Kc expression. For the reaction, the Kc is:
Kc = [H₃O⁺] [F⁻] / [HF]
<em>Because Kc is defined as the ratio between concentrations of products over reactants powered to its reaction coefficient. Pure liquids as water are not taken into account in Kc expression:</em>
<em />
[H₃O⁺] = 0.110g * (1mol /19.01g) = 0.00579moles / 5.6L = 1.03x10⁻³M
[F⁻] = 0.163g * (1mol /19.0g) = 0.00858moles / 5.6L = 1.53x10⁻³M
[HF] = 1.62g * (1mol /20g) = 0.081moles / 5.6L = 0.0145M
Kc = [1.03x10⁻³M] [1.53x10⁻³M] / [0.0145M]
<h3>Kc = 1.09x10⁻⁴</h3>
Answer:
The concentration of the analyte is determined by fitting the absorbance or transmittance obtained by spectrophotometric analysis of the unknown solution into the calibration curve.
Explanation:
In a calibration curve, the instrumental response (absorbance or transmittance), is plotted against the concentration of the analyte (the substance to be measured). The analyst is expected to prepare a series of standard solutions of the analyte within a range of solution concentrations close to the expected concentration of analyte in the unknown solution. The method of least squares may be used to determine the best fit of the line, thus, the concentration of the analyte. This method is only used for the determination of the concentration of coloured substances (spectrophotometry).
Answer:
evaporation, condensation, precipitation, interception, infiltration, percolation, transpiration, runoff, and storage.
Use one of the picture below:
There not . hmm , well where did u get that information from
