Answer:
I believe the answer for this question is D
Explanation:
I hope this helps and is correct
Answer:
I am not 100% sure but i think its because it has moving parts
Explanation:
pls let me know if i was wrong or right in the comments below
hope this helps
Answer:
This is due to difference in bandwidths of different stations, and the inability of the bunny ear to accommodate distant bandwidths most times at the same time.
Explanation:
Bunny ears are a simple half-wave dipole antenna used to receive VHF television bands. It is constructed of two telescoping rods attached to a base, these rods extend out to about 1 meter length, and are collapsible when not in use. For the best reception the rods should be adjusted to be a little less than 1/4 wavelength at the frequency of the television channel being received and bandwidth of different station differs one frone another, so adjustment has to be made sometimes in order to get reception from other stations. Thankfully, the dipole has a wide bandwidth, so most times, adequate reception is achieved without having to adjust the length of the bunny ear.
The half wave dipole of a bunny ear has a low gain of about 2.14 dBi; which means it is not as directional and sensitive to distant stations as a large rooftop antenna, but its wide angle reception pattern may allow it to receive several stations located in different directions without requiring readjustment when the channel is changed. Sometime an adjustment of the rods is necessary.
Cilium are tiny, hair like fiber that aids in movement.
hope the answer helped you.