1) push down on the end of the lever, and 2) 3/4 of the way from the fulcrum
An example of a hypothesis for an experiment might be: “A basketball will bounce higher if there is more air it”
Step one would be to make an observation... “hey, my b-ball doesn’t have much air in it, and it isn’t bouncing ver high”
Step two is to form your hypothesis: “A basketball will bounce higher if there is more air it”
Step three is to test your hypothesis: maybe you want to drop the ball from a certain height, deflate it by some amount and then drop it from that same height again, and record how high the ball bounced each time.
Here the independent variable is how much air is in the basketball (what you want to change) and the dependent variable is how high the b-ball will bounce (what will change as a result of the independent variable)
Step four is to record all of your results and step five is to analyze that data. Does your data support your hypothesis? Why or why not?
You should only test one variable at a time because it is easier to tell why the results are how they are; you only have one cause.
Hope this helps!
Answer:
Explanation:
a ) Conservation of momentum is followed
m₁ v₁ = m₂ v₂
3m x 2 = m v
v = 6 m/s
Total kinetic energy
= 1/2 x .35 x 6 ² + 1/2 x 1.05 x 2 ²
= 8.4 J
This energy must be stored as elastic energy in the spring which was released as kinetic energy on burning the cord.
Yes , the conservation of momentum will be followed in the bursting apart process. Only internal forces have been involved in the process. Two equal and opposite internal forces are created by spring which creates motion and generates kinetic energy.
Answer:
option C
Explanation:
given,
mass of water = 4 Kg
Water is heated to = 800 W
time of immersion = 10 min
= 10 x 60 = 600 s
using equation of specific heat
Q = m S ΔT
S is the specific heat capacity of water which is equal to 4182 J/kg°C.
and another formula of heat
Q = Pt
now,
P t = m S ΔT
800 x 600 = 4 x 4182 x ΔT
ΔT = 29° C
temperature increased is equal to ΔT = 29° C
Hence, the correct answer is option C
Answer and Explanation:
with reference to Einstein's theory of special relativity, the speed of an electromagnetic radiation, here, laser will not change in any inertial frame or remains same irrespective of any change in inertial frame.
Therefore, the speed of light measured in both the cases, i.e., in astronaut's reference frame and spaceship's reference frame will be equal to the speed of light in vacuum, i.e., 
.
The laser gun's speed in astronaut's reference frame is the same as the speed of the spaceship as it mounted on it, i.e., the speed of the laser gun is 200 million m/s.
The laser gun's speed measured in spaceship's reference frame will be zero, as it is mounted on the spaceship and is stationary in the spaceship's reference frame.
