The pseudocode to calculate the average of the test scores until the user enters a negative input serves as a prototype of the actual program
<h3>The errors in the pseudocode</h3>
The errors in the pseudocode include:
- Inclusion of unusable segments
- Incorrect variables
- Incorrect loops
<h3>The correct pseudocode</h3>
The correct pseudocode where all errors are corrected and the unusable segments are removed is as follows:
start
Declarations
num test1
num test2
num test3
num average
output "Enter score for test 1 or a negative number to quit"
input test1
while test1 >= 0
output "Enter score for test 2"
input test2
output "Enter score for test 3"
input test3
average = (test1 + test2 + test3) / 3
output "Average is ", average
output "Enter score for test 1 or a negative number to quit"
input test1
endwhile
output "End of program"
stop
Read more about pseudocodes at:
brainly.com/question/11623795
The HR department could send the email using the blind copy feature to send it to the manager.
The bcc (blind carbon copy) feature will send a copy of the email to the designated person without the primary recipient knowing that it was sent to them. There is no indication in the email that shows that a message was blind copied.
Answer:
Analysis is the right suitable word to complete the sentence
Explanation:
It is because, Analysis is a concept, which means to judge any subjects and brings some original concept which is needed to take from the subjects.
Here in the above question the paragraph states about the summarize points taken from a large amount of data and analysis also mean the same and analysis is also the activity used in NLP for the same as above discussed.
Answer:
hop limit
Explanation:
Hop limit (as called in IPV6), or Time to live (as called in IPV4) is one of the fields in data packet. It is used to limit the life time of a packet in a network by specifying the allowable limit on the number of hops for which a packet is allowed before being removed from the network. It prevents a network from holding a packet forever. So when a router receives a packet, before forwarding it, it decrements the packet's hop limit by 1. If the hop limit gets to zero, any router holding it will drop it rather than forwarding it. This will help remove the packet from the network.
<em>Hope this helps!</em>