<span>calcium is not soluble in water because it reacts to water. It does not dissolve in it.
</span>
Here is some information: "Neon is a chemical element with symbol Ne and atomic number 10. It is in group 18 of the periodic table. Neon is a colorless, odorless, inert monatomic gas under standard conditions, with about two-thirds the density of air. It was discovered in 1898 as one of the three residual rare inert elements remaining in dry air, after nitrogen, oxygen, argon and carbon dioxide were removed. Neon was the second of these three rare gases to be discovered, and was immediately recognized as a new element from its bright red emission spectrum. The name neon is derived from the Greek word, νέον, neuter singular form of νέος, meaning new. Neon is chemically inert and forms no uncharged chemical compounds. The compounds of neon include ionic molecules, molecules held together by van der Waals forces and clathrates."
Also: "Neon is rare on Earth, found in the Earth's atmosphere at 1 part in 55,000, or 18.2 ppm by volume (this is about the same as the molecule or mole fraction), or 1 part in 79,000 of air by mass."
Also I only found one if that is okay but here it is: It is the place where it is a city and most people find most neon there.
Explanation:
Due to the positive value of the change in temperature, this is an endothermic reaction.
Since the forward reaction is endothermic, increasing the temperature increases the equilibrium constant (k).
In an equilibrium system, the position of the equilibrium will move in a way to annul the change made to the system. An increase in temperature for an endothermic reaction would favour the reaction, leading to increase in amount of products and decrease in amount of reactants.
Answer:
The answer is wave B, wave A
Explanation:
The closer the waves the higher the pitch. The higher the waves the louder it is.
The reaction is:
2 NO₂ (g) + F₂ (g) ⇆ 2 NO₂F (g)
The stoichiometric coefficients of the substances balance out each other to obey the Law of Definite Proportions. Now, you have to note that determining the reaction rate expression is specific to a certain type of reaction. So, this are determined empirically through doing experiments. But in chemical reaction engineering, to make things simple, you assume that the reaction is elementary. This means that the order of a reaction with respect to a certain substance follows their individual stoichiometric coefficients. What I'm saying is, the stoichiometric coefficients are the basis of our reaction rate orders. For this reaction, the rate order is 2 for NO₂, 1 for F₂ and 2 for NO₂F. When the forward and reverse reactions are in equilibrium, then it applies that:
Reaction rate of disappearance of reactants = Reaction rate of formation of products.
Therefore, we can have two reaction rate constants for this. But since the conditions manipulated are the reactant side, let's find the expression for reaction rate of disappearance of reactants.
-r = k[NO₂]²[F₂]
The negative sign before r signifies the rate of disappearance. If it were in terms of the product, that would have been positive. The term k denotes for the reaction rate constant. That is also empirical. As you can notice the stoichiometric coefficients are exponents of the concentrations of the reactants. Let's say initially, there are 1 M of NO₂ and 1 M of F₂. Then,
-r = k(1)²(1)
-r = k
Now, if we change 1 M of NO₂ by increasing it to its half, it would now be 1.5 M NO₂. Then, if we quadruple the concentration of F₂, that would be 4 M F₂. Substituting the values:
-r = k(1.5)²(4)
-r = 9k
So, as you can see the reaction rate increase by a factor of 9.
