Answer:
18 is the old value and 12 is the new value. In this case we have a negative change (decrease) of -33.33333333 percent because the new value is smaller than the old value.
Answer:
the largest angle of the field is 149⁰
Step-by-step explanation:
Given;
perimeter of the triangular filed, P = 120 m
length of two known sides, a and b = 21 m and 40 m respectively
The length of the third side is calculated as follows;
a + b + c = P
21 m + 40 m + c = 120 m
61 m + c = 120 m
c = 120 m - 61 m
c = 59 m
B
↓ ↓
↓ ↓
↓ ↓
A → → → → → → → → → → → C
Consider ABC as the triangular field;
Angle A is calculated by applying cosine rule;
Angle B is calculated as follows;
Angle C is calculated as follows;
Therefore, the largest angle of the field is 149⁰.
Answer:
No.
Step-by-step explanation:
For polygon PQRST to be considered a scaled copy of polygon ABCDE, it means every segments of polygon ABCDE were increased proportionally by a scale factor.
The segments in polygon PQRST were not gotten using the same scale factor, hence, it is not a scaled copy of the original polygon, ABCDE.
Segment CD = 2 units, it corresponds to segment RS = 4 units. Scale factor = RS/CD = 4/2 = 2
Segment BC = 1 unit, it corresponds to segment QR = 1 unit. Scale factor = QR/BC = 1/1 = 1 units.
Varying scale factor shows polygon PQRST is not a scaled copy of polygon ABCDE.
Answer:
2.- 100
Step-by-step explanation 1:
↑ As we can see, the only common multiple between 4 and 25 that is given to is 100.
Step-by-step explanation 2:
↑ Another way of knowing the answer is by using a fraction solving method. As we can see, the denominator is once again 100.
Hope it helped,
BiologiaMagister
You have the correct answer. It is choice A. Nice work.
I prefer using full circles because sometimes the arcs could be too small in measure to not go where you want them to. If you're worried about things getting too cluttered (a legitimate concern), then I recommend drawing everything in pencil and only doing the circles as faint lines you can erase later. Once the construction is complete, you would go over the stuff you want to keep with a darker pencil, pen or marker. You can also use the circle as a way to trace over an arc if needed.
Choice B is false as a full circle can be constructed with a compass. Simply rotate the compass a full 360 degrees. Any arc is a fractional portion of a circle.
Choice C is false for similar reasoning as choice B, and what I mentioned in the paragraph above.
Choice D contradicts choice A, so we can rule it out. Arcs are easier to draw since it takes less time/energy to rotate only a portion of 360 degrees. Also, as mentioned earlier, having many full circles tend to clutter things up.
