Answer:If an object's speed changes, or if it changes the direction it's moving in,
then there must be forces acting on it. There is no other way for any of
these things to happen.
Once in a while, there may be a group of forces (two or more) acting on
an object, and the group of forces may turn out to be "balanced". When
that happens, the object's speed will remain constant, and ... if the speed
is not zero ... it will continue moving in a straight line. In that case, it's not
possible to tell by looking at it whether there are any forces acting on it
Answer:
Explanation:
Current, I = 6 A
diameter of wire, d = 2.05 mm
number of electrons per unit volume, n = 8.5 x 10^28
If the diameter is doubled,
The resistance of the wire is inversely proportional to the square of the diameter of the wire, so the resistance is one forth an the current is directly proportional to the diameter of the wire so the current is four times the initial value.
Answer:
1. They generally have poorer fuel efficiency and require more resources to manufacture than smaller vehicles, thus contributing more to climate change and environmental degradation. Their higher center of gravity increases their risk of rollovers.
2. Mid-sized cars and SUVs both have a fixed object fatality rate of 2.6/BVM. This is most likely because they have a similar mass and inertia. The force of the crash is likely to have about the same deceleration in both vehicles.
Explanation:
brainliest please
Answer:
2.06 m/s
Explanation:
From the law of conservation of linear momentum, the sum of momentum before and after collision are equal. Considering this case where we have frictionless surface, no momentum is lost in the process.
Momentum before collision
Momentum is given by p=mv where m and v represent mass. The initial sum of momentum will be 9v+(27*0.5)=9v+13.5
Momentum after collision
The momentum after collision will be given by (9+27)*0.9=32.4
Relating the two then 9v+13.5=32.4
9v=18.5
V=2.055555555555555555555555555555555555555 m/s
Rounded off, v is approximately 2.06 m/s
Answer:
The pressure exerted by the brick on the table is 18,933.3 N/m².
Explanation:
Given;
height of the brick, h = 0.1 m
density of the brick, ρ = 19,300 kg/m³
acceleration due to gravity, g = 9.81 m/s²
The pressure exerted by the brick on the table is calculated as;
P = ρgh
P = (19,300)(9.81)(0.1)
P = 18,933.3 N/m²
Therefore, the pressure exerted by the brick on the table is 18,933.3 N/m².
