The correct answer is MAC (Media Access Control).
<h3>What is MAC?</h3>
The Media Access Control (MAC) protocol is a data link layer protocol that defines the process by which local area network (LAN) devices interface with upper network layer protocols, such as the Internet Protocol (IP).
The MAC protocol is responsible for controlling access to the shared communication medium of the LAN and for providing a reliable link between devices on the LAN. It does this by defining a set of rules and procedures for how devices on the LAN can detect and avoid collisions when transmitting data, as well as for how they can recover from errors that may occur during transmission.
The MAC protocol is typically implemented in hardware, such as in the network interface controller (NIC) of a computer, and is an essential part of the LAN communication process.
To Know More About MAC, Check Out
brainly.com/question/29388563
#SPJ1
Answer:
Following are the program in the C++ Programming Language:
#include <iostream>//header file
using namespace std;//namespane
//set main method
int main() {
int a[100]; //set integer type array variable
int value, i = 0; //set integer variables
cout<<"Enter less than 0 to exit:"<<endl; //message for exit
cout<<"Enter the integer numbers:"<<endl; //message to enter numbers
do{ //set do while
cin>>value; //get input from the user
a[i++] = value; //append elements in array
}while(value>=0);
i--;
cout<<"\nArray are:"<<endl;//message for array
for(int k = 0;k<i;k++){ //set for loop
cout<<a[k]<<" "; //print array
}
return 0;
}
<u>Output</u>:
Enter less than 0 to exit:
Enter the integer numbers:
1
2
3
4
5
-1
Array are:
1 2 3 4 5
Explanation:
Here, we set the integer data type main method "main()" and inside it:
- we set integer type array variable with index value 100.
- we set two integer type variable "value" and "i" initialize value 0.
- we set the do-while loop in which we get the input from the user and and append in the array and pass condition if the value is greater then equal to 0.
- Finally, set for loop and print the elements of an array.
Plagiarism is the answer to the blank
Answer:
you have to let the 3D printer cool off for 15 minutes before turning it back on. once you turned it back on and then you can test the filament and after that it should start working.
Explanation:
so don't touch it for 15 minutes and just leave it alone . if it doesn't work in 15 minutes and leave it for 24 hours completely off and no one touches it.