Answer:- D shows the triangle pairs which can be mapped to each other using a single translation.
Explanation:-
Translation is a rigid transformation which creates a congruent image as that of the original figure such that the distance between the each point of the original figure and the image is fixed and same.
The translation mapping is given by (x,y)→(x+h,y+k) ,where h is the distance of the x coordinate of the each point of the original figure to the image and k is the distance of the y coordinate of the each point of the original figure to the image.
In figure D we can see that the distance between each point of ΔCED is equal to the distance between each point of ΔMPN. Thus it shows the triangle pairs which can be mapped to each other using a single translation.
Answer:
Step-by-step explanation:
At the point where two line cut across, the vertically opposite angles formed are equal. This means that
2x degrees = 78 degrees
Dividing the left hand side and the right hand side of the equation by 2, it becomes
2x/2 = 78/2
x = 39
Checking,
The sum of the angles on a straight line is 180 degrees.
180 - 78 = 102 degrees
2x + 102 = 180
2x = 180 - 102 = 78
x = 78/2 = 39
A ray is a line has one endpoint and a line that goes on forever.
Answer:
See Below.
Step-by-step explanation:
We are given that ΔAPB and ΔAQC are equilateral triangles.
And we want to prove that PC = BQ.
Since ΔAPB and ΔAQC are equilateral triangles, this means that:
Likewise:
Since they all measure 60°.
Note that ∠PAC is the addition of the angles ∠PAB and ∠BAC. So:
Likewise:
Since ∠QAC ≅ ∠PAB:
And by substitution:
Thus:
Then by SAS Congruence:
And by CPCTC:
The missing value x=3 is obtained by the concept of slope in coordinate geometry.
<h3>What is slope?</h3>
Positive or negative rates of change are both possible. Since the slope of a line is determined by the ratio of the vertical and horizontal change between any two locations on a plane or line, the slope is determined by the rise to run ratio. Where, Rise is the difference in elevation between two points. The horizontal shift between two places is known as a run.
Formula of slope = 
(equation 1)
According to the question the coordinates are: xi=2, x2=x, y1=6, y2=10
Given, rate of change=4 (here rate of change=slope)
Putting all coordinates in equation 1
Slope= 
4=4/x-2
x-2=1
x=3
Therefore, the missing value x=3
To know more about slope visit:
brainly.com/question/3605446
#SPJ9
