Answer:
Each axis needs a scale to show the range of the data on that axis. The low end of the scale may be zero or a round number value slightly smaller than the smallest data point. The high end of the scale is usually a round number value slightly larger than the largest data point. The scale is measured off in major and minor tick marks. Typically the scale runs from low to high in easily counted multiples like 10s, 50s, 100s, etc. When graphs are compared side-by-side, consider scaling them to the same data range to make comparisons easier.
Explanation:
thx
Answer:
The options showing the different given statements were not provided in this question; however, an orthopaedic nurse receives specialized education and training to care for patients with diseases and disorders of the musculoskeletal system. Therefore, an orthopedic staff nurse is required to have a knowledge of the following:
1. Orthopedic cases and surgical treatments for each.
2. Surgical site care and dressing.
3. Pain management.
4. Intravenous and Intramuscular drug administration.
5. Vital signs check and significant changes.
6. Post-op care of patient.
7. Casting
8. External fixation care
9. Neurovascular status monitoring
10. Traction
Condensation goes from a gas to a liquid and precipitation is when it rains
Complete Question:
What would most likely be included in the “Analysis” section of a lab report?
1) a discussion of any errors in the experimental data
2) a list the supplies that were used in conducting the experiment
3) suggestions for new experiments based on the results
4) a description of what the dependent and independent variables were
Answer:
1). <u>a discussion of any errors in the experimental data</u>.
In the analysis section of the lab report, after analyzing and investigating the data, errors are identified in the experimental data. Furthermore, discussion carried out to point out those error occurred in the data. In an analysis process discussion is carried out to find the errors in the whole process. In this process all facts and figure are gather to inquire if there are any errors or mistake present in the final values or final result. Analysis section in a lab report has a key role because it make sure that the final result is error free.
