The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
Answer:
24hours
Step-by-step explanation:
let Evan be x, Tyler=x-12,equate;1/x+1/(x-12)=1/8,to get x=24 or 4.The correct value of x=24 because if you take x=4 means that Tyler=-8hours which is impossible
Answer: 0
Step-by-step explanation:
The line runs through the coordinate (0,0), rather than starting at (0,2), (0,4), or (0,8).
Always remember that you read coordinates as (x,y) which..
X is how many spaces right or left
Y is how many spaces up or down.
Answer:
The answer is 0
Step-by-step explanation:
Have a nice day
