Answer:
Step-by-step explanation:
Relationship Equation between time and shrimps cleaned : S = 4T; Relationship is inversely proportional; Unit rate of change = 4
Given : 4 Shrimps cleaned every minute.
So, Shrimps cleaned 'S' = 4 times minutes taken 'T' ; S = 4T
The relationship between variables is proportional, as the dependent variable (shrimps) is constant multiples times the independent variable (time), & their ratio remains constant.
It is directly proportional, as both variables (shrimps & time) move in same direction. One variable increase or decrease, other variable same respectively.
Graph in this case is upward sloping curve from origin, because of direct proportional relationship respectively.
Unit rate of change denotes constant magnitude of change in a variable with other variable. It is 4 in this case, as time increases the shrimps.
Answer:
Surveying a sample would be valid if the population contains a diverse group of people.
Compare the slopes of each line<span>. Remember, when two </span>lines are parallel<span> to each other, they will have the exact same slope. Using the equation y = mx + b where m is the slope of the </span>line<span>, you can </span>identify<span> and compare the slopes of two </span>lines<span>.</span>
(10/n +6) -3
10/2+6-3
5+6-3
11-3
8
Hope this helped!
<span>Naming of rays
Rays are commonly named in two ways:
By two points.
In the figure at the top of the page, the ray would be called AB because starts at point A and passes through B on it's way to infinity. Recall that points are usually labelled with single upper-case (capital) letters. There is a symbol for this which looks like this: AB This is read as "ray AB". The arrow over the two letters indicates it is a ray, and the arrow direction indicates that A is the point where the ray starts.
By a single letter. (I have not seen this done.)
The ray above would be called simply "q". By convention, this is usually a single lower case (small) letter. This is normally used when the ray does not pass through another labeled point.</span>