Answer:
1.5024
Explanation:
Draw a diagram. Put the two cells in series. Now draw 3 resistors. Two of them equal 0.26 ohms each. The third one is the lightbulb which is 12 ohms.
R = 0.26 + 0.26 + 12 = 12.52
The bulb has a voltage of 2.88 volts across it. You can get the current from that.
i = E / R
i = 2.88 / 12 =
i = 0.24 amps.
Now you can get the voltage drop across the two cells.
E = ?
R = 0.26
i = 0.24 amps
E = 0.26 * 0.24
E = 0. 0624
Finally divide the 2.88 by 2 to get 1.44
Each cell has an emf of 1.44 + 0.0624 = 1.5024
Answer:
Q = 12540 J
Explanation:
It is given that,
Mass of water, m = 50 mL = 50 g
It is heated from 0 degrees Celsius to 60 degrees Celsius.
We need to find the energy required to heat the water. The formula use to find it as follows :

Where c is the specific heat of water, c = 4.18 J/g°C
Put all the values,

So, 12540 J of energy is used to heat the water.
Answer:
75.71 m/s
Explanation:
From equation of motion, acceleration is given by
where v is the final velocity, u is the initial velocity and t is time taken.
Making v the subject of the above formula
v=at+u
Substituting 6.7 s for time, t and 11.3 for a and taking u as zero since it starts from rest
v=11.3*6.7=75.71 m/s
Answer:
c. The steady-state value of the current depends on the resistance of the resistor.
Explanation:
Since all the components are connected in series, when the switch is at first open, current will not flow round the circuit. As current needs to flow through from the positive terminal of the battery through the resistor, inductor, and switch to the negative terminal of the battery.
But the moment the switch is closed, at the initial time t = 0, the current flow through from the positive terminal of the battery through the resistor, inductor, and switch to the negative terminal of the battery. It then begins to increase at a rate that depends upon the value of the inductance of the inductor.