<span>3Ca + 2AlPO4 -> 2Al + Ca3(PO4)2 . . .the coefficient for Ca is 3.</span>
Answer:- The gas needs to be transferred to a container with a volume of 11.2 L.
Solution:- From Boyle's law. "At constant temperature, Volume is inversely proportional to the pressure."
It means, the volume is decreased if the pressure is increased and vice versa.
Here, the Pressure is decreasing from 537 torr to 255 torr. So, the volume must increase and calculated by using the equation:
Where, 
is initial pressure and 
is final pressure. Similarly, 
is initial volume and 
is final volume.
Let's plug in the values in the equation:
(537 torr)(5.30 L) = (255 torr)()
= 11.2 L
So, the new volume of the container needs to be 11.2 L.
Hello. You forgot to replace the map needed to answer that question. The map is attached below:
Answer:
B) west to east
Explanation:
The letter H on the map represents an area with high air pressure, while the letter L represents an area with low air pressure. As in the areas of lower temperature or colder the pressure is greater, the wind leaves these areas and goes towards those of higher temperature, which present less pressure. For this reason, we can say that the wind is moving from west to east.
The greater the pressure difference between the regions, the greater the wind speed, and in these situations, strong winds or winds can occur, which are given different names, depending on the location: hurricane (Caribbean), tornado (USA), typhoon (Asia).
Answer:
Substances can change phase—often because of a temperature change. At low temperatures, most substances are solid; as the temperature increases, they become liquid; at higher temperatures still, they become gaseous.
The process of a solid becoming a liquid is called melting. (an older term that you may see sometimes is fusion). The opposite process, a liquid becoming a solid, is called solidification. For any pure substance, the temperature at which melting occurs—known as the melting point—is a characteristic of that substance. It requires energy for a solid to melt into a liquid. Every pure substance has a certain amount of energy it needs to change from a solid to a liquid. This amount is called the enthalpy of fusion (or heat of fusion) of the substance, represented as ΔHfus. Some ΔHfus values are listed in Table 10.2 “Enthalpies of Fusion for Various Substances”; it is assumed that these values are for the melting point of the substance. Note that the unit of ΔHfus is kilojoules per mole, so we need to know the quantity of material to know how much energy is involved. The ΔHfus is always tabulated as a positive number. However, it can be used for both the melting and the solidification processes as long as you keep in mind that melting is always endothermic (so ΔH will be positive), while solidification is always exothermic (so ΔH will be negative).
