Answer:
Port security and violation mode.
Explanation:
A switch is a layer two device of the OSI model. It is used to transmit frames between nodes within a network. It transfers frames by discovering the destination Mac address and saving it to its address table, and sending the frame to the egest port to the destination.
The port security command is used to specify the Mac addresses that are recognised by a port. There are three types of port security, they are, dynamic, static and sticky Mac addresses that can configured on an interface.
The security violation command is used to decide what happens to a port when it detects an unfamiliar Mac address. The three security violation modes are protect, restrict and shutdown. It is used as an interface command alongside the port security command.
Answer:
1
11
111
1111
11111
Explanation:
Given
The above QBasic code
Required
The output
The iteration on the third line is repeated 5 times; i.e. for values of j from 1 to 5.
In each iteration, the value of N is printed and the next value is calculated.
Initially, the value of N is 1 ---- on line 2
So, 1 is printed first. The next value of N is as follows:
--- we keep replacing N (on the right-hand side) with current N value.
So, we have:




The answer is true and i believe it is best to put it at the 4 intersecting points<span />
Answer:
Thank you! can i have brainliest please?
Explanation:
I believe it is C, I'm so sorry if im incorrect.